User manual HUSQVARNA TR530

[. . . ] Start the engine carefully according to instructions and with feet well away from the tool(s). Stop the engine: - whenever you leave the machine and before refuelling. Reduce the throttle setting during engine shut down and, if the engine is provided with a shut-off valve, turn the fuel off at the conclusion of working. Keep all nuts, bolts and screws tight to ensure the equipment is in safe working condition. [. . . ] Use clean 30 or 10W-30 grade oil and store in approved, clean covered containers. (Do not use pressurized starting fluid, as severe internal engine damage may occur due to loss of lubrication. Starting the engine 9) 1/3 of the way towards the high speed position. Pull rope out slowly until engine reaches start of compression cycle (rope will pull slightly harder at this point). Keep drive control bar in "disengaged" position when starting the engine (fig. In order to idle smoothly, a new engine may require 3 to 5 minutes running time above slow idle speed. Idle speed has been adjusted to be correct after this break-in period. Always release drive control bar before moving shift lever into another position. Don't back yourself into a solid obstruction such as a tree, fence, etc. 10) to slow position and allow the engine to run at low speed for 1 or 2 minutes before moving throttle to stop position. 10) slowly and return the handle to its original position when reistance is felt. This operation is necessary to prevent outside moist air from intruding into the combustion chamber. Swing the handle in the opposite direction you wish to turn, being careful to keep feet and legs away from the tines. 10) are slotted so that they can be raised for deep tilling and lowered for shallow tilling to protect small plants from being buried. Lower the depth stake to its lowest position and insert the depth stake pin in the topmost hole. Always release drive control bar before moving shift lever into another position. Tilling is digging into, turning over and breaking up packed soil before planting. Tines will not readily penetrate dry, hard soil which may contribute to excessive bounce and difficult handling of your tiller. Hard soil should be moistened before tilling: however, extremely wet soil will "ball-up" or clump during tilling. For easier handling of your tiller, leave about 8 inches of untilled soil between the first and second tilling passes. [. . . ] A badly worn tine causes your tiller to work harder and dig shallower. Most important, worn tines can not chop and shred organic matter as effectively nor bury it as deeply as good tines. To maintain the superb tilling performance fo this machine the tines should be checked for sharpness, wear and bending, particulary the tines which are next to the transmission (fig. Never tamper with the engine governor, which is factory set for proper engine speed. [. . . ]