User manual HUSQVARNA TB1000

[. . . ] NB: The machine can be used with just 4 drills: 2 initial drills (L) and 2 disc drills (M). Fit them in the direction in which the drills will rotate, with the ring facing towards the back of the machine (see sketch). Fight the right (F) and left (E) protection wings and fix them on the machine with 6 screws (10) and 6 nuts (16). Insert the right-hand (I) and left-hand lower steering bars (J) in their respective housings on the block (B) and fix them on each side with a screw (12). [. . . ] Start the machine carefully, in accordance with the manufacturer's instructions and keeping your feet away from the tools. Always remove the safety cut-out any time that the machine will be left unobserved. The operator must pay particular attention on hard or stony ground because the machine has the tendency to be much less stable than on cultivated ground and use slow speed for ploughing. Use the transport wheel and a ramp to lift the machine into a vehicle or onto a trailer. Maintenance / Storage / Accessories Before storing the machine in a confined or closed space, let it cool down for at least 5 minutes. Keep the nuts, bolts and screws tightened to ensure that the equipment is in a safe operating condition. Regular servicing is essential for safety and for maintaining the level of performance. To reduce the risk of fire, keep the motor, the battery compartment and the storage area clear of vegetation and surplus grease. Switch the machine off by removing the safety cut-out in the following cases: - Before working on the tools. - Before any cleaning or checking operations , or repairs to the machine. - If you bump into a foreign body, inspect the machine to check whether it is damaged. - If the machine starts to vibrate abnormally, immediately seek cause of the vibration and make the necessary repairs or ensure that they are carried out. It is the owner's responsibility to ensure that these tools or accessories are certified as being in accordance with the prevailing safety regulations. Always remove the safety cut-out before performing any leaning operations. Handle the battery carefully so as not to create a short circuit between conductive materials such as, necklaces, rings, bracelets or keys. In the event of a short circuit, the battery or the conductive materials may overheat and cause burns. Battery safety instructions Do not charge the battery in a damp place. Do not try to replace the individual batteries inside the battery unit. Mixing new and discharged batteries together would increase the internal pressure in the elements, which would cause the discharged to break down. Connecting the battery unit incorrectly could cause a leak or an explosion. Do not open the battery because the electrolyte, the acid that it contains, is corrosive and would damage your eyes, skin or clothing. The acid is also toxic if swallowed or if the fumes it gives off are inhaled. [. . . ] If you remain in movement mode too long, the machine will switch off automatically to protect the battery. â· If the temperature inside the machine becomes too high, the machine restricts the power and then switches off automatically. â· The battery life varies according to various parameters, such as the condition of the ground and its humidity and the operating depth, which can accelerates the rate at which the batteries discharge and therefore reduces the area worked. Als het accu pack bijna leeg is, gaat de machine over van de werk modus in de verplaatsing modus en wordt de LED oranje, in dit geval moet u het accu pack zo snel mogelijk opladen. [. . . ]