User manual HUSQVARNA T55 R

[. . . ] Before using your cultivator, please make sure you have understood the contents of this manual. For your own sake, we advise you not to alter the characteristics of your machine, and to use only the maker's recommended blades and accessories. Never let the cultivator be used by children, or by anyone unfamiliar with the instructions. [. . . ] If any of the following happens, first stop the motor and remove the cable from the spark plug: - Whenever you have to adjust the blades, - Whenever you clean, service or repair the cultivator, - If you hit a foreign body, inspect the machine to see if it has been damaged. - If the cultivator starts vibrating in an abnormal way, immediately look for the cause of the trouble and make any necessary repairs. Stop the motor if either of the following happens: - Whenever the cultivator is to be left unattended, - Before adding petrol. When about to engage the blades, make sure there is nobody in front of or close to the cultivator. Hold the handlebar tight - it has a tendency to lift when the blades engage. While working, keep at a safe handlebar's length from the blades. Remove all stones, wire, glass, metal and loose objects from the area to be dug. Do not alter the adjustment of the motor's speed regulator; do not over-rev. Spares of substandard quality may damage the machine and endanger your safety. To avoid fire risk, wait until the motor has cooled down before putting it away. Before putting the cultivator away remove any loose vegetation, especially around the motor once it has cooled. To reduce the risks of fire, keep the silencer and the area around the fuel tank free from leaves and oil. If the petrol tank needs emptying, do this in the open air and with the motor cold. Never store it with petrol in the tank, in a place where petrol vapour might reach a flame, a spark or a source of strong heat. Ask two other people to help, lifting by holding on to the handlebars and the blade axles. Tenance is important both for safety's sake and to sustain the machine's performance. [. . . ] Do not use inflammable solvents to clean the foam insert in the air filter. 1: Remove the cable from the sparking plug (see the motor manual) 2: Remove the belt housing 3: In forward gear, check rotation of the blades (A). After several hours' use, if reverse motion malfunctions, adjust the cable as follows: 6: Check the 73 mm measurement 7: If the measurement is not 73 mm, adjust according to A - B - C (D). [. . . ]