User manual HUSQVARNA ROYAL 43 EL

[. . . ] B installed 100% safety cannot be guaranteed and safe working practice must be followed at all times. Before use, examine cable for damage, replace it if there are signs of damage or ageing. Do not use the lawnmower if the electric cables are damaged or worn 4. Immediately disconnect from the mains electricity supply if the cable is cut, or the insulation is damaged. [. . . ] Do not use your lawnmower until you are sure that the entire lawnmower is in a safe operating condition; if the lawnmower starts to vibrate abnormally. Keep all nuts, bolts and screws tight to be sure the lawnmower is in safe working condition. Only use the replacement blade, blade bolt, spacer and impeller specified for this product. Be careful during adjustment of the machine to prevent entrapment of the fingers between moving blades and fixed parts of the machine. Your product is uniquely identified by a silver and black product rating label. To ensure you have full product information when obtaining spares or advice from one of our approved service centres or if you need to contact our customer service department you should make a note in the space provided of the information shown in Fig B Secure the lower handle with the handle knobs provided. Make sure the switchbox is on the right hand side when viewed from the rear. (C2) Fit the cable to the handles with the clips provided making sure the cable is not trapped between the upper and lower handles. Take the lid, align the tabs with the slots and press firmly together. Fit the 2 location E studs on the safety flap into the 2 location holes on the grassbox lid and ensure the grassbox is securely located. (E) IMPORTANT After fitting ensure no gap remains between the safety flap and grassbox lid. Where grass collection is not required you can use the lawnmower without the grass collector. Ensure the safety flap is fully closed Lower the assembled D4 screen into the grass box, aligning the tabs with the slots in the grassbox and press firmly together. Form loop in mains cable and push the loop through the slot as illustrated in picture F1. To secure, position loop over the hook F2 and pull the cable back through the slot as illustrated in picture F2. Loosen locknut (J1) and screw adjuster (J2) "IN", in the direction of the arrow, if clutch does not engage when the clutch lever is pulled towards the handle. Screw adjuster (J2) "OUT", in the opposite direction from the arrow, it the clutch lever does not disengage when the the clutch lever is free. Press and hold the lock off button on the switchbox, (G1) then squeeze the Start/Stop lever towards the upper handle (G2). Start mowing from the outside edge of the lawn, mowing in strips in alternate directions (K). Mow twice a week in the growing season, your lawn will suffer if more that one third of its length is cut at one time and this may also result in poor collection. Please Note:Do not overload your Lawnmower When mowing in long thick grass a first cut with the cutting height adjusted to its highest setting, see Cutting Height, will help reduce motor overload and will help prevent damage to your lawnmower. When the indicator drops outs of sight - it's time to empty the grassbox. [. . . ] ENVIRONMENTAL INFORMATION Electrolux Outdoor Products are manufactured under an Environmental Management System (ISO 14001) using, where practical, components manufactured in the most environmentally responsible manner, according to company procedures, and with the potential for recycling at the end of the products' life. Awareness of the environment must be considered when disposing of `end-oflife' product. Se alltid till att Du har båda händerna i körläge när Du för tillbaka gräsklipparen till marken. Certify that the Lawnmower:6UP Certify that a sample of the above 6UP Certify that a sample of the above Category. [. . . ]