User manual HUSQVARNA ROYAL 53 S INTEK

[. . . ] Do not attempt to charge other products with the charger from this unit. Charging should only be carried out in a safe location where neither battery nor cord cable can be trodden on or tripped over. Ensure that neither the charger nor the battery are exposed to moisture. Read the user instructions carefully to make sure you understand all the controls and what they do. [. . . ] To reduce fire hazard, keep the engine, silencer, battery compartment and fuel storage area free of grass, leaves or excessive grease. Be careful during adjustment of the machine to prevent entrapment of the fingers between moving blades and fixed parts of the machine. Your product is uniquely identified by a silver and black product rating label. To ensure you have full product information when obtaining spares or advice from one of our approved service centres or if you need to contact our customer service department you should make a note in the space provided of the information shown in Fig B Your product is supplied with the handles folded over the product. Adjust handle assembly to the most comfortable operating position (C3) and tighten handle adjusters (C2) on both sides of the product Pull the Operator Presence Control (D1) to release the brake on the engine. You must release the brake by pulling the OPC lever to the handle before pulling out the cord. Please Note :- Ensure no gap remains between the safety flap and the grassbox Where grass collection is not required you can use the lawnmower without the grassbox. Ensure the safety flap is fully closed Check oil level periodically and after every five hours of operation. Add oil as necessary to keep the level to the FULL mark on the dipstick. Change the oil after the first five hours operation and thereafter every 25 F2 working hours. Always change the oil while the engine is warm - but not hot never attempt any maintenance on a hot engine. To avoid introducing dirt into the fuel system, wipe all grass and dirt from the petrol filler cap before unscrewing it. It is recommended that you fill the tank through a funnel with G2 a filter. Please Note :- move the product away from the fuelling area before starting Please Note:- When starting the engine for the first time, fill with oil and petrol as described above in the Oil and Petrol section. Advance engine speed control to FAST as illustrated in the Use - starting and stopping section. Move engine speed control to FAST Push primer bulb (H) firmly five times Position and push primer bulb firmly three times before starting engine. (if engine stopped because it ran out of fuel, refuel engine - push primer bulb three times. If engine fails to start after three pulls of the pull cord, push primer bulb three times and repeat step 3. Move the Engine Speed Control to the FAST `+' position before starting. Pull the operator presence control (OPC) to release the brake on the engine and the J2 blade. [. . . ] Store in a cool, dry place where your lawnmower is protected from damage. Service Recommendations We strongly recommend that your product is serviced at least every twelve months, more often in a professional application. engine Maintenance Schedule Follow the hourly or calendar intervals , whichever occur first. More frequent service is required when operating in adverse conditions First 5 hours - Change oil. [. . . ]