User manual HUSQVARNA ROYAL 50 S BBC

[. . . ] Do not attempt to charge other products with the charger from this unit. Charging should only be carried out in a safe location where neither battery nor cord cable can be trodden on or tripped over. Ensure that neither the charger nor the battery are exposed to moisture. Read the user instructions carefully to make sure you understand all the controls and what they do. [. . . ] Ensure the safety flap is fully closed Check oil level periodically and after every five hours of operation. Add oil as necessary to keep the level to the FULL mark on the dipstick. Change the oil after the first five hours operation and thereafter every 25 F2 working hours. Always change the oil while the engine is warm - but not hot never attempt any maintenance on a hot engine. To avoid introducing dirt into the fuel system, wipe all grass and dirt from the petrol filler cap before unscrewing it. It is recommended that you fill the tank through a funnel with G2 a filter. Please Note :- move the product away from the fuelling area before starting Please Note:- When starting the engine for the first time, fill with oil and petrol as described above in the Oil and Petrol section. Advance engine speed control to FAST as illustrated in the Use - starting and stopping section. Move engine speed control to FAST Push primer bulb (H) firmly five times Position and push primer bulb firmly three times before starting engine. (if engine stopped because it ran out of fuel, refuel engine - push primer bulb three times. If engine fails to start after three pulls of the pull cord, push primer bulb three times and repeat step 3. Move the Engine Speed Control to the FAST `+' position before starting. Pull the operator presence control (OPC) to release the brake on the engine J2 and the blade. Pull the recoil starter fully towards you until you feel the full resistance, return the handle slowly then pull the handle firmly towards you to its full extent. After the engine has started, allow to run for 30 seconds before commencing to use. Forward drive is engaged and recoil disengaged with the Powerdrive lever at the top of the handle (J4). Engaging the Drive - See Royal 50S Drive speed can be L drive speed altered with the drive control speed control. Please note:- Your Royal 50SE can be started manually by following steps 1-5 in Starting & Stopping Royal 50S Key Start Only - During mowing, your engine will recharge the battery Turn the key and hold until the engine starts (K). If the engine fails to start when you turn the key your battery may need charging. While holding the BBC arm, push forward BBC control lever until a click is heard (M2). Release the BBC control lever which will return to its original position. Please Note: Leaving the engine running without the blade rotating for an extended length of time could lead to the engine overheating. [. . . ] Service Recommendations We strongly recommend that your product is serviced at least every twelve months, more often in a professional application. engine Maintenance Schedule Follow the hourly or calendar intervals , whichever occur first. More frequent service is required when operating in adverse conditions First 5 hours - Change oil. Every 25 hours or every season - Change oil if operating under heavy load or high ambient temperature. [. . . ]