User manual HUSQVARNA ROYAL 49 SE

[. . . ] Do not attempt to charge other products with the charger from this unit. Charging should only be carried out in a safe location where neither battery nor cord cable can be trodden on or tripped over. Ensure that neither the charger nor the battery are exposed to moisture. Read the user instructions carefully to make sure you understand all the controls and what they do. [. . . ] Adjust handle assembly to the most comfortable operating position (C3) and tighten handle adjusters (C2) on both sides of the product Pull the Operator Presence Control (D1) to release the brake on the engine. ROYAL 49S AND ROYAL 49SE ONLY You must release the brake by pulling the OPC lever to the handle before pulling out the cord. Please Note :- Ensure no gap remains between the safety flap and the grassbox Where grass collection is not required you can use the lawnmower without the grassbox. Ensure the safety flap is fully closed Check oil level periodically and after every five hours of operation. Add oil as necessary to keep the level to the FULL mark on the dipstick. Change the oil after the first five hours operation and thereafter every 25 F2 working hours. Always change the oil while the engine is warm - but not hot never attempt any maintenance on a hot engine. To avoid introducing dirt into the fuel system, wipe all grass and dirt from the petrol filler cap before unscrewing it. It is recommended that you fill the tank through a funnel with G2 a filter. Please Note :- move the product away from the fuelling area before starting Please Note:- When starting the engine for the first time, fill with oil and petrol as described above in the Oil and Petrol section. Advance engine speed control to FAST as illustrated in the Use - starting and stopping section. Move engine speed control to FAST Push primer bulb (H) firmly five times Position and push primer bulb firmly three times before starting engine. (if engine stopped because it ran out of fuel, refuel engine - push primer bulb three times. If engine fails to start after three pulls of the pull cord, push primer bulb three times and repeat step 3. Move the Engine Speed Control to the FAST `+' position before starting. Pull the operator presence control (OPC) to release the brake on the engine and the J2 blade. Pull the recoil starter fully towards you until you feel the full resistance, return the handle slowly then pull the handle firmly towards you to its full extent. After the engine has J3 started, allow to run for 30 seconds before commencing to use. Forward drive is engaged and disengaged with the Powerdrive lever at the top of the handle (J4). If the engine fails to start when you turn the key your battery may need charging. Please note:- Your Royal 49SE can be started manually by following steps 1-5 in Starting & Stopping Royal 49S Key Start Only - During mowing, your engine will recharge the battery Engaging the Drive - See Royal 49S Stopping - See Royal 49S Starting & Stopping Royal 49S/BBC (BBC - Blade, Brake , Clutch) 1. While holding the BBC L1 arm, push forward BBC control lever until a click is heard (L2). [. . . ] Never use a damp cloth or flammable liquids such as petrol, white spirits, thinners etc. The engine brake cable should always be adjusted to stop the engine within 3 sec. Ask your local Service Centre to clean the air filter thoroughly and carry out any service or repairs required. Store in a cool, dry place where your lawnmower is protected from damage. [. . . ]