User manual HUSQVARNA ROYAL 46

[. . . ] Tilting or lifting the lawnmower may cause stones to be thrown out Keep bystanders away. Do not mow whilst people especially children or pets are in the mowing area Beware or severing toes or hands. Disconnect the spark plug before attempting any maintenance, cleaning or adjustment, or if you are going to leave the lawnmower unattended for any period. Wait until all machine components have completely stopped before touching them. [. . . ] Do not use your lawnmower until you are sure that the entire lawnmower is in a safe operating condition. Reduce the throttle setting during engine shut down and, if the engine is provided with a shut-off valve, turn the fuel off at the conclusion of mowing. Keep all nuts, bolts and screws tight to be sure the lawnmower is in safe working condition. Only use the replacement blade, blade bolt, spacer and impeller specified for this product. Never store the lawnmower with fuel in the tank inside a building where fumes can reach an open flame or spark. To reduce fire hazard, keep the engine, silencer, battery compartment and fuel storage area free of grass, leaves or excessive grease. Be careful during adjustment of the machine to prevent entrapment of the fingers between moving blades and fixed parts of the machine. Your product is uniquely identified by a silver and black product rating label. To ensure you have full product information when obtaining spares or advice from one of our approved service centres or if you need to contact our customer service department you should make a note in the space provided of the information shown in Fig B Your product is supplied with the handles folded over the product. Adjust handle assembly to the most comfortable operating position (C3) and tighten handle adjusters (C2) on both sides of the product Pull the Operator Presence Control (D1) to release the brake on the engine. ROYAL 50S AND ROYAL 50SE ONLY You must release the brake by pulling the OPC lever to the handle before pulling out the cord. Please Note: Leaving the engine running without the blade rotating for an extended length of time could lead to the engine overheating. Engaging the Drive - See Royal 50S Drive speed can be altered with the drive speed control. Start mowing from the outside edge of the lawn, mowing in strips in alternate directions (N2). Mow twice a week in the growing season, your lawn will suffer if more that one third of its length is cut at one time and this may also result in poor collection. Please Note:Do not overload your Lawnmower When mowing in long thick grass a first cut with the cutting height adjusted to its highest setting, see Cutting Height, will help reduce engine overload and will help prevent damage to your lawnmower. The height of cut is altered by pulling the adjustment lever away from the location slots and moving to the selected position (N3). Your lawnmower has a grass collection indicator which tells you when the grassbox needs emptying. When the indicator is at the top of the tube, grass is being collected. When the indicator starts to drop, it's time to empty the grassbox. Adopt a stationary position, keeping the lawnmower running for 10 seconds. Stop your lawnmower as described in Use starting and stopping, and disconnect the spark plug. [. . . ] Using a soft brush P3 remove grass clippings from the engine air intakes and exhaust (P3), cutting height adjustment area. Fit the blade to the machine with the sharp edges pointing away from the machine. * Clean more often under dusty conditions, or when airborne debris is present or after prolonged operation cutting tall, dry grass. Engine Servicing & Guarantee The engine fitted to your lawnmower is guaranteed by the Engine Manufacturer. [. . . ]