User manual HUSQVARNA ROYAL 36 EL

[. . . ] Your extension cable must be uncoiled, coiled cables can overheat and reduce the efficiency of Always keep the lawnmower on the your mower. Keep cable away from lawnmower, always work the lawnmower may cause stones to away from the power point mowing up and down, be thrown out never in circles. Never pull on the cable to disconnect any of the whilst people especially children or pets plugs. Remove plug from mains disconnecting any plug, cable connector or before adjusting, cleaning or if cable is extension cable. [. . . ] Pull the tie spindle bar (A1) to one side so that it is flush with hole in the side of the moulding. Push the tie bar back through the locating hole in the handle and secure it with a handle knob (A). Make sure the switchbox is on the right hand side when viewed from the rear. Fit the cable to the handles with the clips provided making sure the cable is not trapped between the upper and lower handles. Align the matching tabs and slots in the back and sides of the grassbox screen and press firmly together (E2). Lower the assembled screen into the grassbox, aligning the tabs with the slots in the grassbox and press firmly together (E4, E5). Take the lid, align the tabs with the slots and press firmly together (E6). Fit the 2 location studs on the safety flap into the 2 location holes on the grassbox lid and ensure the grassbox is securely located (F). IMPORTANT After fitting ensure no gap remains between the safety flap and grassbox lid. Removal is the reverse procedure Where grass collection is not required you can use the lawnmower without the grass collector. Make sure the switchbox is on the right hand side when viewed from the rear. Fit the cable to the handles with the clips provided making sure the cable is not trapped between the upper and lower handles. Form loop in mains cable and push the loop through the slot as illustrated in picture G1. To secure, position loop over the hook and pull the cable back through the slot as illustrated in picture G2. Starting the Lawnmower The switchbox is provided with a lock off button (H1) to prevent accidental starting. Press and hold the lock off button on the switchbox (H1), then squeeze the start/stop lever towards the upper handle (H2). Continue to squeeze the start/stop lever and release the lock off button. Loosen locknut (L1) and screw adjuster (L2) "IN", in the direction of the arrow, if clutch does not engage when the clutch lever is pulled towards the handle. Screw adjuster (L2) "OUT", in the opposite direction from the arrow, if the clutch does not disengage when the clutch lever is free. Start mowing from the outside edge of the lawn, mowing in strips in alternate directions (M). Mow twice a week in the growing season, your lawn will suffer if more that one third of its length is cut at one time and this may also result in poor collection. Please Note:Do not overload your Lawnmower When mowing in long thick grass a first cut with the cutting height adjusted to its highest setting, see Cutting Height, will help reduce motor overload and will help prevent damage to your lawnmower. [. . . ] Store in a cool, dry place where your lawnmower is protected from damage. Immediately disconnect from the mains electricity supply and consult your local approved Service Centre. Clean the outside of the air intakes, the discharge chute and the underside of the deck. Immediately disconnect from the mains electricity supply and consult your local approved Service Centre. [. . . ]