User manual HUSQVARNA PP 480 HF

[. . . ] Please read the operator's manual carefully and make sure you understand the instructions before using the machine. The machine can be a dangerous tool if used incorrectly or carelessly, which can cause serious or fatal injury to the operator or others. Please read the operator's manual carefully and make sure you understand the instructions before using the machine. Approved protective helmet Approved hearing protection Protective goggles or a visor Breathing mask Protective goggles or a visor must be worn. [. . . ] If you get into a situation where you feel unsafe, stop and seek expert advice. the owner is responsible for ensuring that the operators receive training. Check that all couplings, connections and cables are intact and free from dirt. Check that all cables and the water supply are correctly connected to the machine before starting it. Never pull out the power cable without first switching off the power unit and waiting for the engine to come to a complete halt. If an emergency situation should arise anyway, push the red emergency stop button on the power unit or the stop button on the remote control. Make sure that sparks are not caused when cutting in view of the risk of explosion. Make sure that no pipes or electrical cables are routed in the area to be cut. Always saw in a manner that permits easy access to the emergency stop. Make sure that there is always another person close at hand when you use the machines, so that you can call for help if an accident should occur. Do not use the machine in bad weather, such as dense fog, rain, strong wind, intense cold, etc. Working in bad weather is tiring and can lead to dangerous conditions, e. Ensure that the working area is sufficiently illuminated to create a safe working environment. You are handling heavy parts, which implies the risk of pinch injuries or other injuries. do not expose the machine to temperatures exceeding 45°C or to direct sunlight. Do not use the machine in wet or humid surroundings, close to water, in the rain or snow. Do not wash the machine with water, as water can enter the electrical system or the engine and cause damage to the machine or short circuit. Always switch of the power unit and pull out the electric cable before moving the equipment. Store the equipment in a lockable area so that it is out of reach of children and unauthorized persons. If there is a risk of freezing, the machine must be drained of any remaining water coolant. PP 480 HF is supplied with the following equipment: 1 x power unit 1 x remote control 1 x power lead 1 x Canbus cable 1 x water hose Transport boxes for smooth transport. It is our wish that you will be satisfied with your product and that it will be your companion for a long time. [. . . ] If there is a risk of freezing, the machine must be drained of any remaining water coolant. Read through the manual supplied with the wall saw for further instructions in sawing technique. After 100 hours of operation, the message "Time for servicing" is displayed. The entire equipment shall then be taken to an authorized Husqvarna dealer for servicing. [. . . ]