User manual HUSQVARNA PP 455 E

[. . . ] Please read the operator's manual carefully and make sure you understand the instructions before using the machine. The machine can be a dangerous tool if used incorrectly or carelessly, which can cause serious or fatal injury to the operator or others. Please read the operator's manual carefully and make sure you understand the instructions before using the machine. Approved protective helmet Approved hearing protection Protective goggles or a visor Breathing mask Protective goggles or a visor must be worn. [. . . ] Phase 1, Phase 2, Phase 3 Settings Time Total machine time Battery status (only machines equipped with a radio) Radio channel (only machines equipped with a radio) The time is counted from when the saw starts working. With the Canbus cable Connect the Canbus cable between the remote control and the unit. Make sure that none of the emergency stops are pushed in and that the power unit is voltage fed. With the charging cable Connect the charging cable between the remote control and the 12 volt outlet in the car. To charge with the battery charger Connect the charging cable between the remote control and the battery charger. When you select time ON (and when the hydraulic unit is operational, see 1. Different messages are shown on the display, depending what is currently happening with the battery: · When the remote control is connected and the battery is being charged a horizontal column is shown below the 0 % 100 % scale. The column length against the scale shows how much of the charge remains in the battery. When the remote control is only used in battery mode, a radio antenna must first be connected to the unit: Remove any cable connection. The message is also shown when the charging unit in the remote control has been damaged. The emergency stop on the remote control should always be in the extended position when charging. All Setting options for the hydraulic unit and the remote control are accessed via this sub-menu. The SETTINGS" menu consists of seven sub-menus, which in turn consist of a number of part menus: 1. The end point value should be adjusted so that the blade rotation is as high as possible when the blade rotation knob is turned to the right. A too low value results in full power from the hydraulic unit never being reached. The ramp time value states how fast the blade's speed of rotation shall change when the blade rotation knob is turned. A too low value means the blade motor's hydraulic system will start to self-oscillation. Using this sub-menu you can set the language you wish to use on the display. This sub-menu contains setting options for the rotation of the blade and consists of three part menus: 2. This sub-menu contains setting options for blade feed, both horizontally and depth. The start point value should be adjusted so that the blade rotation is as low as possible when the blade rotation knob (pos. A too low value results in the need to turn the knob before the blade starts to rotate. [. . . ] If the voltage is still low, the electric motor is turned off and the low voltage error message is shown. By pressing OK, the unit returns to the maximum power you selected at start up. To switch between 63 A and 32 A, the unit must be turned off and then on again. read the supply voltage on the operations menu Phase 1 , Phase 2 , Phase 3". [. . . ]