User manual HUSQVARNA PP 440 HF

[. . . ] This machine is only intended for use together with a Husqvarna WS 440 HF. Read through the manual supplied with the wall saw before starting to use the hydraulic unit. You must use approved personal protective equipment whenever you use the machine. Personal protective equipment cannot eliminate the risk of injury but it will reduce the degree of injury if an accident does happen. [. . . ] The machine must not be run with defective or disassembled safety equipment. Never allow anyone else to use the machine without first ensuring that they have understood the contents of the operator's manual. People and animals can distract you causing you to lose control of the machine. Be careful as clothing, long hair, and jewellery can get caught in moving parts. You are handling heavy parts, which implies the risk of pinch injuries or other injuries. the owner is responsible for ensuring that the operators receive training. Check that all couplings, connections and cables are intact and free from dirt. Check that all cables and the water supply are correctly connected to the machine before starting it. Never pull out the power cable without first switching off the power unit and waiting for the engine to come to a complete halt. If an emergency situation should arise anyway, push the red emergency stop button on the power unit or the stop button on the remote control. Make sure that sparks are not caused when cutting in view of the risk of explosion. Make sure that no pipes or electrical cables are routed in the area to be cut. Always saw in a manner that permits easy access to the emergency stop. Make sure that there is always another person close at hand when you use the machines, so that you can call for help if an accident should occur. Do not use the machine in bad weather, such as dense fog, rain, strong wind, intense cold, etc. Working in bad weather is tiring and can lead to dangerous conditions, e. Ensure that the working area is sufficiently illuminated to create a safe working environment. You are handling heavy parts, which implies the risk of pinch injuries or other injuries. Always switch of the power unit and pull out the electric cable before moving the equipment. Store the equipment in a lockable area so that it is out of reach of children and unauthorised persons. If there is a risk of freezing, the machine must be drained of any remaining water coolant. PP 440 is a power unit specially developed to be used with the electric wall saw WS 440 HF. [. . . ] Let the water coolant circulate the power unit for a minute before you turn the blade rotation on again. Check that the power lead is fitted correctly and that it is not damaged. Fault on HAL-sensor card for travel feed Fault on HAL-sensor card for depth feeding No contact between power unit and remote control Make sure to keep the connectors and pins clean. Cutting at too high revs can cause damage to the blade and lead to personal injury. [. . . ]