User manual HUSQVARNA PP 325 E

[. . . ] This machine is primarily intended for WS 325, DM 406 H, HS 170 and HH 170, but is also highly suitable as power source for other equipment, e. Read through the manual supplied with the hydraulic tool before starting to use the machine. You must use approved personal protective equipment whenever you use the machine. Personal protective equipment cannot eliminate the risk of injury but it will reduce the degree of injury if an accident does happen. [. . . ] Avoid unfavourable weather conditions and body contact with lightning conductors and metal objects. Always switch off the power to the hydraulic unit and pull out the electric cable before moving the equipment. If there is a risk of freezing, the machine must be drained of any remaining water coolant. The power unit is constructed as a wheeled cart with the possibility of hanging hydraulic hoses for simple transportation at the workplace. For transportation between workplaces, the power unit should be stored in vertical position with the distribution box facing upwards. Store the equipment in a lockable area so that it is out of reach of children and unauthorized persons. Never use the machine if you are tired, if you have drunk alcohol, or if you are taking medication that could affect your vision, your judgement or your co-ordination. Keep all cords and extension cords away from water, oil and sharp edges. When replacing hoses, hoses marked 'non-conducting dielectric" must be used. The hoses must be regularly checked for their electrical conductive insulation in accordance with special instructions. Working close to gas conduits: Always check and mark out where gas pipes are routed. Make sure that sparks are not caused when cutting in view of the risk of explosion. Run the hydraulic system until it reaches its operation temperature of 30°C before starting to saw, to reduce return pressure and other wear. Always saw in a manner that permits easy access to the emergency stop. Make sure that there is always another person close at hand when you use the machines, so that you can call for help if an accident should occur. People that need to be in close proximity of the machine must wear hearing protection as the sound level when cutting exceeds 85 dB(A). Do not use the machine in bad weather, such as dense fog, rain, strong wind, intense cold, etc. Working in bad weather is tiring and can lead to dangerous conditions, e. Ensure that the working area is sufficiently illuminated to create a safe working environment. You are handling heavy parts, which implies the risk of pinch injuries or other injuries. This information is never a substitute for professional skills and experience. If you get into a situation where you feel unsafe, stop and seek expert advice. [. . . ] When starting, the switch must only be turned to "START 5 SEC" for about 5 seconds. The engine may be damaged if the switch is in the "START 5 SEC" position too long or when operated. The start takes place in two steps to avoid overloading the fuse the machine is connected to. Working pressure, bar / psi Hose length (1/2" hose), mm/inch 9, 3/12, 6 40/8, 8 12/2, 6 Water cooling 575x1040x780/22, 6x40, 9x30, 7 93/205 140/2031 8/315 (When hoses are extended beyond standard length, 5/8" hose is recommended. [. . . ]