User manual HUSQVARNA LTH174

[. . . ] Instruction manual Please read these instructions carefully and make sure you understand them before using this machine. Prezechowywanie Uskladnenie Tárolás 3 18 23 31 33 43 74 77 We reserve the right to make changes without prior notice. Safety Rules Safe Operation Practices for Ride-On Mowers IMPORTANT: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROWING OBJECTS. € Never allow children or people unfamiliar with the instructions to use the lawnmower. [. . . ] The cutting result is best with high engine speed (blades rotate quickly) and low gear (machine goes slowly). If the grass is not too long and thick the drive speed can be increased by selecting a higher gear or increasing the motor speed, without affecting the cutting result. Cutting becomes more even and the cut grass is more evenly distributed over the surface. Total time taken is not greater, since higher drive speed can be selected without affecting the cutting results. The cutting results will be worse since the wheels will sink into the soft lawn. € • • Do not drive in terrain at an angle of more than max. € • Drive in right turns so that the cut grass is thrown away from flower beds and paths, etc. For larger lawns the drive direction should be changed after 2-3 turns so that the cut grass is thrown towards the area that has already been cut as shown in the illustration. Use the left side of the machine to cut close to trees, bushes and paths, etc. 41 5 Switching off the engine Move the attachment clutch control to disengaged position. Move the throttle control between half and full speed (fast) position. Lift up the cutting unit and turn the ignition key to “STOP” position. Do not leave the ignition key in the machine when not in use to prevent children and other unauthorized persons starting the engine. Before servicing the engine or cutting unit the following shall be carried out: • Press down the clutch/brake pedal and engage the parking brake lever. Maintenance NOTE: Periodic maintenance should be performed on a regular basis in order to keep your tractor in good running condition. WARNING: Disconnect spark plug wire to prevent accidental starting before attempting any repair, inspection, or maintenance. Before each use: • Check oil, lubricate pivot points as necessary. € Check to see all bolts, nuts, and cotter pins are in place and secure. € Keep tractor free of dirt and chaff to prevent engine damage or overheating. Water can enter engine and transmission and shorten the useful life of the machine. Tapón de drenaje 1 3 2 TO CHANGE OIL CAUTION: If engine has been operated for an extended period of time immediately prior to draining oil, oil will be hot. € Loosen and remove oil drain plug with 1/2" (12 Point)socket wrench (extension recommended). [. . . ] For accurate reading, be sure key remains in the “STOP” position when engine is not running. 70 6 WASCHANLAGEN-ÖFFNUNG DER ABDECKUNG A B DECK WASHOUT PORT Your tractor’s deck is equipped with a washout port on its surface as part of its deck wash system. € Drive the tractor to a level, clear spot on your lawn, near enough to a water spigot for your garden hose to reach. IMPORTANT: Make certain the tractor’s discharge chute is directed AWAY from your house, garage, parked cars, etc. [. . . ]