User manual HUSQVARNA LTH126

[. . . ] Please read these instructions carefully and make sure you understand them before using this machine. ⷠNever allow children or people unfamiliar with the instructions to use the lawnmower. ⷠNever mow while people, especially children, or pets are nearby. ⷠKeep in mind that the operator or user is responsible for accidents or hazards occurring to other people or their property. [. . . ] Let the ignition key return to the "ON" position when the engine has started Push the gas control to the required speed. To ensure proper operation and performance, it is recommended that the transmission be purged before operating tractor for the first time. This procedure will remove any trapped air inside the transmission which may have developed during shipping of your tractor. ⷠDepress forward drive pedal to full forward position, hold for five (5) seconds and release pedal. Depress reverse drive pedal to full reverse position, hold for five (5) seconds and release pedal. ⷠStop tractor by turning ignition key to "OFF" position. ⷠDrive tractor forward for approximately five feet then backwards for five feet. The machine is equipped with a safety switch which immediately breaks the current to the engine if the driver leaves the seat with engine running and with the connection/ disconnection lever in position "connection". The direction and speed of movement is controlled by the forward and reverse drive pedals. Cutting Lower the cutting unit by moving the lift lever forward and connect the cutting unit. Choose a driving speed which suits the terrain and required cutting results. Any attempt by the operator to travel in the reverse direction with the attachment clutch engaged will shut off the engine unless ignition key is placed in the ROS "ON" position. Backing up with the attachment clutch engaged while mowing is strongly discouraged. Turning the ROS "ON", to allow reverse operation with the attachment clutch engaged, should only be done when the operator decides it is necessary to reposition the machine with the attachment engaged. uSING THE ROS · With engine running, turn ignition key counterclockwise to ROS "ON" position. When use of the ROS is no longer needed, turn the ignition key clockwise to engine "ON" position. Clear the lawn from stones and other objects which can be thrown away by the blades. Water can enter engine and transmission and shorten the useful life of the machine. Fill in dates as you complete regular service As Needed Every 8 hours Every 25 hours Every . Be sure operator presence and reverse operation systems are working properly. If your tractor does not function as described, repair the problem immediately. ⷠThe engine should not start unless the brake pedal is fully depressed, and the attachment clutch control is in the disengaged position. [. . . ] To service engine and mower, see the Maintenance section of this manual. NOTE: Service reminder runs when the ignition key is in any position but "STOP". For accurate reading, be sure key remains in the "STOP" position when engine is not running. Your tractor's deck is equipped with a washout port on its surface as part of its deck wash system. [. . . ]