User manual HUSQVARNA LTH112

[. . . ] Such instruction should emphasize: - the need for care and concentration when working with ride-on machines; - control of a ride-on machine sliding on a slope will not be regained by the application of the brake. The main reasons for loss of control are: a) insufficient wheel grip; b) being driven too fast; c) inadequate braking; d) the type of machine is unsuitable for its task; e) lack of awareness of the effect of ground conditions, especially slopes; f) incorrect hitching and load distribution. Do not operate the engine in a confined space where dangerous carbon monoxide fumes can collect. Before attempting to start the engine, disengage all blade attachment clutches and shift into neutral. [. . . ] Never leave the key in the ignition lock when leaving the machine on its own. To release the parking brake all that is necessary is to push down the brake pedal. To tow or move the tractor without the aid of the engine, the free-wheel control knob must be pulled out and locked in position. Do not smoke when filling with petrol or fill up when the engine is warm. The combined oil refilling cap and the oil stick is accessible when the bonnet is lifted forwards. If more oil is needed add SAE 30 oil to the "FULL " marking. SAE 5W-30 oil should be used during the winter (below freezing point). Make sure that the cutting unit is in the transport position (top position) and that the lever for connection/disconnection of the cutting unit is in the disconnection position. If the engine will not start, wait about 10 seconds before the next try. Let the ignition key return to the "ON" position when the engine has started Push the gas control to the required speed. To ensure proper operation and performance, it is recommended that the transmission be purged before operating tractor for the first time. For larger lawns the drive direction should be changed after 2-3 turns so that the cut grass is thrown towards the area that has already been cut as shown in the illustration. Use the left side of the machine to cut close to trees, bushes and paths, etc. Switching off the engine move the attachment clutch control to disengaged position. Move the throttle control between half and full speed (fast) position. Lift up the cutting unit and turn the ignition key to "STOP" position. Do not leave the ignition key in the machine when not in use to prevent children and other unauthorized persons starting the engine. Before servicing the engine or cutting unit the following shall be carried out: · Grasp hood at sides, tilt forward and lift off of tractor. NOTE: Periodic maintenance should be performed on a regular basis in order to keep your tractor in good running condition. WARNING:Disconnect spark plug wire to prevent accidental starting before attempting any repair, inspection, or maintenance. Check to see all bolts, nuts, and cotter pins are in place and secure. IMPORTANT: To ensure proper assembly, center hole in blade must align with star on mandrel assembly. [. . . ] TRANSAXLE PUMP FLUID The transaxle was sealed at the factory and fluid maintenance is not required. Should the transaxle ever leak or require servicing, contact your nearest authorized service center/ department. Service reminder shows the total number of hours the engine has run and flashes to indicate that the engine or mower needs servicing. When service is required, the service reminder will flash for two hours. [. . . ]