User manual HUSQVARNA LR111

[. . . ] Stop the blades from rotating before crossing surfaces other than grass. When using any attachments, never direct discharge of material toward bystanders nor allow anyone near the machine while in operation. Never operate the lawnmower with defective guards, shields or without safety protective devices in place. Operating the engine at excessive speed may increase the hazard of personal injury. [. . . ] Keep all nuts, bolts and screws tight to be sure the equipment is in safe working condition. Never store the equipment with petrol in the tank inside a building where fumes may reach an open flame or spark. To reduce the fire hazard, keep the engine, silencer, battery compartment and petrol storage area free of grass, leaves, or excessive grease. On multi-bladed machines, take care as rotating one blade can cause other blades to rotate. When machine is to be parked, stored or left unattended, lower the cutting means unless a positive mechanical lock is used. CAUTION: Always disconnect spark plug wire and place wire where it cannot contact spark plug in order to prevent accidental starting when setting up, transporting, adjusting or making repairs. These symbols may appear on your tractor or in the literature supplied with the product. These symbols may appear on your tractor or in the literature supplied with the product. Mutter Bag of parts (contents not shown full size) · Remove box of parts · NOTE: If battery is put into service after month and year indicated on label, charge battery for minimum of one hour at 6-10 amps. WARNING: Before installing battery remove metal bracelets, wrist watch bands, rings, etc. WARNING: Positive terminal must be connected first to prevent sparks from accidental grounding. Re-insert trunnion into bracket with pin pointing to left hand side of tractor. Measure distance from ground to lower flange of mower deck on both sides of mower (dim. To raise left side of mower, loosen upper trunnion nut and tighten the lower trunnion nut. To lower left side of mower, loosen lower trunnion nut and tighten upper trunnion nut. nOTE: One rotation of lower trunnion nut is equivalent to approximately 1/8 inch of height change. Be sure both trunnion nuts are tightened against trunnion after adjustment. Level mower front to rear For best cutting results, the rear of the mower should be 1/4 to 3/8 inch higher than the front of the mower. Measure distance from ground line to lower flange of deck at right front and right rear (dim. Raise or lower rear of mower housing by adjusting right rear lift link. To raise rear of mower housing, loosen upper trunnion nut and tighten lower trunnion nut. To lower rear of mower housing, loosen lower trunnion nut and tighten upper trunnion nut. [. . . ] Fill in dates as you complete regular service As needed Change engine oil Lubricate pivot points Check brake operation Clean air screen Clean air filter and pre-cleaner Replace air cleaner paper cartridge Clean engine cooling fins Replace spark plug Check tire pressure Replace fuel filter Clean battery and terminals Check muffler Lubricate ball joints Toe-in adjustment Carburetor adjustment V-Belt adjustment Every 8 hours Every 25 hours Every 50 hours Every 100 hours Every 200 hours WARNING: If tractor takes more than six feet stopping distance in highest gear, then brake must be adjusted. Adjust the distance if necessary by first loosening the lock nut (2) and then adjusting with the nut (1). TO ADJUST MOTION CONTROL LEVER The motion control lever has been preset at the factory and adjustment should not be necessary. If for any reason the motion control lever will not hold its position while at a selected speed, it may be adjusted at the friction pack located on the right side of transmission. [. . . ]