User manual HUSQVARNA LR 122

[. . . ] LR122 OWNER'S MANUAL SAFETY RULES Safe Operation Practices for Ride-On Mowers IMPORTANT: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROWING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. I. • • • • • • • • • • • • • • • GENERAL OPERATION Read, understand, and follow all instructions in the manual and on the machine before starting. Only allow responsible adults, who are familiar with the instructions, to operate the machine. Clear the area of objects such as rocks, toys, wire, etc. , which could be picked up and thrown by the blade. [. . . ] • Remove retainer springs and washers from mower stabilizer link. • Withdraw front lift link, rear lift links and mower stabilizer link from brackets. • Slide mower deck out on right side of tractor. MOWER UPSTOP ADJUSTMENT (See Fig. 19) • Raise attachment lift lever to highest (transport) position. • Measure distance from top of mower deck to lower flange of chassis (dim. Remove washer and retainer spring in trunnion, then withdraw trunnion pin from bracket. Loosen trunnion locknut and rotate trunnion counterclockwise on lift link to increase dim. Repeat adjustment if necessary. LOWER FLANGE OF CHASSIS “A” TOP OF MOWER DECK TO INSTALL MOWER (See Fig. 18) • Reverse removal instructions. ENGINE PULLEY MOWER CLUTCH SPRING BELT MOWER CLUTCH ARM AXLE BRACKET RETAINER SPRING WASHER FRONT LIFT TRUNNION RETAINER SPRING WASHER BRACKET TRUNNION LOCKNUT FIG. 19 MOWER STABILIZER LINK REAR LIFT LINKS FRONT LIFT LINK FIG. 18 15 SERVICE AND ADJUSTMENTS TO LEVEL MOWER HOUSING (See Figs. 20-23) Adjust the mower while tractor is parked on level ground or driveway. If tires are over or under inflated, you will not properly adjust your mower. NOTE: One rotation of trunnion nut is equivalent to approximately 1/8 inch of height change. Be sure upper and lower nuts are tightened against trunnion after adjustment has been completed. • Place attachment height adjustment knob in position “3” (See Fig. 21 and 22) • Measure distance from ground to lower flange of mower deck on both sides of mower (dim. • To raise left side of mower, loosen upper trunnion nut and tighten lower trunnion nut. • To lower left side of mower, loosen lower trunnion nut and tighten upper trunnion nut. 22 and 23) To obtain the best cutting results, the mower housing should be adjusted so the rear is approximately 1/4" to 3/ 4" higher than the front when the mower is in height adjustment position “3”. • Measure distance from ground line to lower flange of deck at right front and right rear (dim. “D” & “E”) in line with front and rear tires. [. . . ] ANY IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED TO WARRANTIES OF MERCHANTABILITY AND FITNESS FOR ANY PARTICULAR PURPOSE WHICH DANA CORPORATION, SPICER-OFF-HIGHWAY AXLE DIVISION, IS SO FORBIDDEN TO DISCLAIM BY ANY APPLICABLE LAW, ARE LIMITED TO THE PERIODS OF THE EXPRESSED WARRANTY. DANA CORPORATION, SPICER-OFF-HIGHWAY AXLE DIVISION, SHALL IN NO EVENT BE LIABLE FOR ANY CONSEQUENTIAL, INCIDENTAL OR SPECIAL DAMAGES AND OR EXPENSES. Some states do not allow limitations on warranties so the above limitation may not apply to you. This Warranty gives you specific legal rights, and you may also have other rights which vary from state to state. [. . . ]