User manual HUSQVARNA JET 46 R

[. . . ] - If petrol is spilled, do not attempt to start the engine but move the machine away from the area of spillage and avoid creating any source of ignition until petrol vapors have dissipated. Before using, always visually inspect to see that the blades, blade bolts and cutter assembly are not worn or damaged. replace worn or damaged blades and bolts in sets to preserve balance. On multi-bladed machines, take care as rotating one blade can cause other blades to rotate. [. . . ] On multi-bladed machines, take care as rotating one blade can cause other blades to rotate. Do not operate the engine in a confined space where dangerous carbon monoxide fumes can collect. For wheeled rotary machines, mow across the face of slopes, never up and down. Use extreme caution when reversing or pulling the lawnmower towards you. stop the blade if the lawnmower has to be tilted for transportation · When crossing surfaces other than grass, and when transporting the lawnmower to and from the area to be mowed. Never operate the lawnmower with defective guards, or without safety devices, for example deflectors and/or grass catchers, in place. Operating the engine at excessive speed may increase the hazard of personal injury. Start the engine or switch on the motor carefully according to instructions and with feet well away from the blade. Do not tilt the lawnmower when starting the engine or switching on the motor, except if the lawnmower has to be tilted for starting. In this case, do not tilt more than absolutely necessary and lift only the part which is away from the operator. Push cable forward until speed lever touches boss and tighten clamp screw. Install rope guide into side of upper handle and secure with 1/4-20 locknut. Hold brake yoke down to upper handle and slowly pull out the starter rope until the rope will slip into loop of the rope guide. Place discharge guard on top of discharge opening of lawn mower housing. ⷠPlace bracket on top of discharge guard, position bracket and guard on mower and secure with bolts and nuts supplied. NOTE: The foot guard must be installed for the safe operation of this machine. To start a cold engine, push primer three (3) times before trying to start. This step is not usually necessary when starting an engine which has already run for a few minutes. ⷠHold engine brake yoke to the handle and pull on starter handle quickly. In warmer weather over priming may cause flooding and engine will not start. [. . . ] ⷠHold engine brake yoke to the handle and pull on starter handle quickly. In warmer weather over priming may cause flooding and engine will not start. If you do flood the engine wait a few minutes before attempting to start and DO NOT repeat priming steps. The mower should not be used on ground that slopes more than 15°. [. . . ]