User manual HUSQVARNA HVA TE, TC, SMR 2006

[. . . ] Unless specified, data and presciption are referred to all t he models. Your new Husqvarna motorcycle is designed and manufactured to be the finest in its field. The instructions in this book have been prepared to provide a simple and understandable guide for your motorcycle's operation and care. Follow the instructions carefully to obtain maximum performance and your personal motorcycling pleasure. [. . . ] The springs available upon request, together with the preload spacers, are shown on pages . Remove plug (B) and turn register (A) clockwise until the position of fully closed is reached then, turn back by the mentioned clicks. To reset standard calibration turn register (C) clockwise to reach the position of fully closed; then, turn back by the mentioned clicks. WARNING: Never force the adjusting screws beyond the maximum opening and closure positions. OIL FORK LEVEL For the regular fork operation, both legs must be provided with the necessary oil quantity. Remove the forkrods form the fork to check the oil level inside the forkrods. Work as follows: - remove the power rod caps; - remove springs from the stems letting the oil drop into the latter; - bring forks to stroke end; - check that the level is at distance "A" below the upper limit of rods. NOTE Besides the serial spring (21) with flexibility index K=4, 8 N/mm (TETC) and K=5 (SMR) and relevant preload (25) spacer harder or softer springs, together with spacers are abailable upon request. NOTE Always replace both the spring and the spacers to keep the preload value unchanged. HANDLEBAR POSITION AND HEIGHT CHANGE The handlebar position (a) and height (b) can be changed for better suiting Your driving requirements. To effect these operations, remove the upper screw (3), upper clamp (1), lower screw (4) then lower clamp (2). A) Handlebar position change Turn the lower clamp (2) 180° to move forward or backward (10mm- 0. B) Handlebar height change Remove the lower spacer (A) then replace the screw (4) with a new one of L=65 mm (2. Once these operations are completed, tighten the screws (3) to 2, 75-3, 05 kgm (27-30 Nm; 19. ADJUSTING THE SHOCK ABSORBER The rear shock absorber must be adjusted according to the rider weight and track conditions. Take the normal riding position on the motorcycle with all your riding apparel. The difference between these two measurements constitutes the "SAG" of the motorcycle's rear end. To get the right SAG according to your weight, adjust the shock absorber spring preload (page 146). First turn counterclockwise fastening rear pin (1) then remove saddle, screws (2) and R. When the adjusting operation is over (according to your weight and riding style), tighten the ringnut. WARNING*:Be careful not to touch hot exhaust pipe while adjusting the shock abosrber. SHOCK ABSORBER DAMPING ADJUSTMENT (BEFORE the following operation, please see the IMPORTANT NOTICE 2) on page 12 Adjustment of the compression stroke is independent from the rebound stroke. [. . . ] 2) Where to be careful Avoid spraying water with any great force near the following places: G Air cleaner G Under the fuel tank: If water gets into the ignition coil or into the spark plug cap, the spark will jump through the water and be grounded out. When this happens, the motorcycle will not start and the affected parts must be wiped dry. - Briefly warm-up the engine - Test the brakes before riding the motorcycle. When remove greasers (1) to lubricate rear suspension link needle bearings, it's necessary to lubricate shock absorber lower needle bearing (2) too: remove nut (3) and bushing. [. . . ]