User manual HUSQVARNA FS 700 EX

[. . . ] Warning A large warning triangle with the text "Warning" signifies that there is a risk of serious personal injury or even death. Note A smaller warning triangle with the text "Note" signifies that there is a risk of minor personal injury or damage to the machine. During the design and production of Husqvarna products, great importance is placed on safety, as well as effectiveness and ease of use. To ensure that the machine remains safe you must pay attention to the following points: · Note that under no circumstances may the machine be started without following the safety instructions. [. . . ] If the foot lever is switched to the other position no gear is engaged and the machine is easy to move. Use this position when the machine needs to be transported over long distances. Handle setting The height of the handle can be adjusted by loosening these two screws to the most suitable height. Hose holder The user can use the hose holder to prevent hoses and cables trailing behind the machine. Blade guard Can be fitted on either the right or left-hand side of the machine as required. The guard can be secured in the upright position by using the lever on the rear edge of the guard. Splash guard The machine is equipped with a folding splash guard to minimise water spray and dirtying. When the machine is transported over long distances the splash guard should be folded up and secured using the spring on the blade guard. Blade flange The blade flange fits on either side of the machine to allow the blade to be easily fitted on both sides of the machine The blade flange should be covered with the blade flange guard when a blade is not fitted The blade flange guard is fitted on the right-hand side on delivery. Fit the blade on the flush cutting blade flange when the cut is to be made next to a wall. We recommend that Husqvarna W1100 series blades are used together with the machine Weight (excl. Speed drive shaft: ______________ 1780 rpm Periphery speed, saw blade ___________ 56 m/s Maximum blade diameter _____________ 725 mm max. NOTE When unsure about the significance of the technical specifications or when ordering spare parts please contact your dealer. Noise emissions (see note 1) Sound power level, measured dB(A) Sound power level, guaranteed dB(A) Sound levels (see note 2) Sound pressure level at the operators ear, dB(A) Vibration levels, ahv (see note 3) Handle right, m/s2 Handle left, m/s2 1, 3 1, 2 93 114 115 Under no circumstance may the machine be modified without written permission from Husqvarna Construction Products Sweden AB. Non approved modifications put you and others at risk of serious or fatal injuries. Husqvarna Construction Products Sweden AB bears no responsibility for operations or measures that do not follow these instructions. Note 1: Noise emissions in the environment measured as sound power (LWA) in conformity with EC directive 2000/14/EC. Reported data for noise pressure level has a typical statistical dispersion (standard deviation) of 1. Enclose the area to be cut so that unauthorised persons can not be injured or disturb the operator while working. Clearly mark out all cuts to be made on the floor before you start sawing, plan these so they can be carried out without danger to persons or the machine. In order to prevent stoppages and sources of irritation while cutting, plan the work so that you fit the blade to the most appropriate side of the machine from the outset. Check that you have the right saw blade for the machine and the material to be cut. [. . . ] Pull a part the cogs that drive the saw forwards by inserting a screwdriver between the cogs and carefully pressing the screwdriver downwards. The electrical connection must be disconnected before carrying out maintenance repairs and service-work When storing the machine for long periods it must be cleaned carefully and the water tank emptied. NOTE Before rectifying a fault, check that all electrical connections are disconnected to prevent the machine from starting during the course of the work. If a fault occurs, first check whether it coincides with any of the possible faults in the trouble shooting guide below. [. . . ]