User manual HUSQVARNA FS 513

[. . . ] Operator's manual Please read the operator's manual carefully and make sure you understand the instructions before using the machine. Before operating machine, read and understand this entire operation manual & engine operation manual supplied with engine. Model Identification: Record machine serial number plate information below for future reference Thank you for purchasing your new machine from Husqvarna Construction Products. We have provided important safety messages in this manual and on the machine. [. . . ] Tools: Use machine only with the following tools (H): Water Cooled Diamond Blades. Reinforced Abrasive Blades or Dry Cutting Diamond blades should NOT be used within European Union (EU) regions because this machine, as supplied, does not include a dust collector port. Operator must wear personal protective equipment & clothing appropriate to the work he is doing. Personal protective equipment, such as hearing & eye protection, is mandatory. DO NOT use carbide, wood saw, or circular saw blades on this machine, else injury or death could occur. Blade Guard (C) is factory installed on right hand side of machine, but can be relocated to left side. This may allow cutting closer to obstacles, if approaching them from the opposite direction is not possible. Use mm Wrench (U) to remove Blade Guard Rear Bolt (E) from Blade Guard (C). Lower Blade Guard (C) onto Blade Guard Mounting Spade (Y) on left hand side of machine. Use a proper lifting strap rated for at least the maximum mass of the machine. The nominal and maximum mass of the machine are shown in the TECHNICAL DATA section of this document. Pivot front of water tank upward until it rests against aluminum cowl top. Do not rest water tank cap against plastic cowl front - damage during lifting could occur. Test Lift machine at a low level (just a few centimeters) to verify tank remains secured to machine, and will not be damaged or cause damage. If water tank equiped machine can not be lifted without damage to the machine or tank, remove water tank before lifting. Parking Brake for this machine is applied using Transmission Engagment Lever (PP). Parking brake is designed to hold machine in position on a slope of 0 degrees or less, with rear of machine on downhill side of slope (maximum weight on braked wheel). Move Transmission Engagment Lever (PP) forward to "engaged" position. OIL: Check that engine oil level is correct using the Engine Oil Dipstick (Z). See Maintenance section of this document or engine operation manual for more information. Because the engine often operates at an angle, check oil level with engine horizontal. Check frequently to ensure that oil level never falls below lower mark on dipstick. [. . . ] It should be periodically verified after machine is placed into service. To assure proper Governor adjustment, determine correct blade shaft speed (RPM) from the adjacent chart. Service of Hydrostatic Transmission (TT): Maintenance free for life of machine. Re-check tension after - hours of operation and re-tighten to original tension if required - see steps - below. [. . . ]