User manual HUSQVARNA FS 410 D

[. . . ] Operator's manual - Please read the operator's manual carefully and make sure you understand the instructions before using the machine. 35 Model Identification: Record machine serial number plate information below for future reference Before operating machine, read and understand this entire operation manual & engine operation manual supplied with engine. Thank you for purchasing your new machine from Husqvarna Construction Products. We have provided important safety messages in this manual and on the machine. [. . . ] Allow other persons to be near the machine when starting, refueling, or when the machine is in operation. Operate this machine unless you are specifically trained for its operation. DO NOT modify this saw or use for any application other than for which it was designed. If you have any questions relative to its application, DO NOT use the saw until you have written Husqvarna Construction Products and we have advised you. Can be used when Blade Guard (C) is mounted to left or right side of machine H. Blade: Tool that cuts asphalt or concrete material ­ not included with machine. Engine Oil Dipstick: Use to check engine oil level (Not Shown ­ See Operation Section of this document). Blade Depth Control: Turn Counter-Clockwise to raise Diamond Blade (H) and Clockwise to lower Diamond Blade (H). Pull Blade Depth Stop toward rear of machine and turn 90 degrees to lock in open position. Operation: With engine OFF ("0"), lower Diamond Blade (H) until in contacts the cutting surface. Engine Tachometer (RPM): Shows engine speed in revolutions per minute if engine is running. Total operation time shown in minutes from 0-9 minutes, and hours for 0+ minutes. Rear Handle: Operator position is behind machine with both hands on Rear Handle. Operation: To engage, rotate lever upward, so rod is allowed to move inward. To dis-engage, pull rod inward and rotate downward so rod is fixed in the inward position. Assemble the following items before operating machine for the first time. Using screws, washers and nuts installed in the Front Pointer (A), install onto tube frame of Water Tank Support (N). Operator must wear personal protective equipment & clothing appropriate to the work he is doing. Personal protective equipment, such as hearing & eye protection, is mandatory. DO NOT use carbide, wood saw, or circular saw blades on this machine, else injury or death could occur. Blade Guard (C) is factory installed on right hand side of machine, but can be relocated to left side. This may allow cutting closer to obstacles, if approaching them from the opposite direction is not possible. [. . . ] When checking oil level, Engine Oil Dipstick (Z) should not be screwed in. Because engine often operates at an angle, check oil level with engine horizontal. Check frequently to ensure that oil level never falls below lower mark on dipstick. Set a suitable container, large enough to hold engine oil capacity, beside machine to catch oil. [. . . ]