User manual HUSQVARNA DM 330

[. . . ] Maximum speed is reached about three seconds after the machine is turned on. In SmartstartTM mode the machine has less power until the button is pressed in again. These functions are of great use for creating a pilot hole for drilling. It is our wish that you will be satisfied with your product and that it will be your companion for a long time. [. . . ] The machine must always be used with an isolating transformer for protection in case an electrical fault should occur. Failure to follow the warnings and instructions may result in electrtic shock, fire and/or serious injury. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. People and animals can distract you causing you to lose control of the machine. Do not use the machine in bad weather, such as dense fog, heavy rain, strong wind, intense cold, etc. Working in bad weather is tiring and can lead to dangerous conditions, e. Never start to work with the machine before the working area is clear and you have a firm foothold. Ensure that no material can become loose and fall, causing injury when operating the machine. Always check the rear side of the surface where the drill bit will emerge when drilling right through. Secure and cordon off the area and make sure that no one can be injured or material damaged. Never use the machine if you are tired, if you have drunk alcohol, or if you are taking medication that could affect your vision, your judgement or your co-ordination. Ensure the switch is in the OFF-position before connecting to power source. Carrying power tools with your finger on the switch or energising power tools that have the switch on invites accidents. A wrench or a key left attached to a rotating part of the power tool may result in personal injury. Never allow anyone else to use the machine without first ensuring that they have understood the contents of the operator's manual. Be careful as clothing, long hair, and jewellery can get caught in moving parts. Make sure that no pipes or electrical cables are routed in the area to be drilled. Never work alone, always ensure there is another person close at hand. Apart from being able to receive help to assemble the machine, you can also get help if an accident should occur. Avoid unfavourable weather conditions and body contact with lightning conductors and metal objects. Do not wash the machine with water, as water can enter the electrical system or the engine and cause damage to the machine or short circuit. Check that the cord and extension cord are intact and in good condition. [. . . ] Make sure that the side with the copper wire is facing the gear box and that the carbon brush slides easily in the brush retainer. If the carbon brush is fitted in the wrong direction it can get jammed. Check that the cord and extension cord are intact and in good condition. Important All types of repairs may only be carried out by authorised repairmen. [. . . ]