User manual HUSQVARNA 966445001

[. . . ] Study the operating instructions and safety precautions thoroughly to insure proper functioning of your Grass Catcher and to prevent injury to yourself and others. Save this manual for future reference. WARNING! Engine exhaust, some of its constituents, and certain vehicle components contain or emit chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. The operation of any mower can result in foreign objects thrown into the eyes, which can result in severe eye damage. ALWAYS wear safety glasses or eye shields before starting your mower and while mowing. Standard safety glasses are recommended or a wide vision safety mask for over spectacles. SAFETY SAFE OPERATION PRACTICES FOR RIDE-ON MOWERS DANGER ! THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROWING OBJECTS. [. . . ] Wrap the blade(s) or wear gloves, and use extra caution when servicing them. Adjust and service as shown in the Operator’s Manual. • • CHILDREN • • • • • • • • • • • • • • SERVICE • • • 6 SAFETY SAFE OPERATION PRACTICES FOR RIDE-ON MOWERS • • • • NEVER allow children to operate the machine. They may fall off and be seriously injured or interfere with safe machine operation. Keep children out of the mowing area and under the watchful care of another responsible adult. If tires lose traction, disengage the blades and proceed slowly straight down the slope. If machine stops while going uphill, disengage blades, shift into reverse and back down slowly. Do not turn on slopes unless necessary, and then, turn slowly and gradually downhill, if possible. CAUTION In order to prevent accidental starting when setting up, transporting, adjusting or making repairs, always disconnect spark plug wire and place wire where it cannot contact spark plug. • • • • • • WARNING Engine exhaust, some of its constituents, and certain vehicle components contain or emit chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. • • • • CAUTION Look for this symbol to point out important safety precautions. YOUR SAFETY IS INVOLVED. WARNING Battery posts, terminals and related accessories contain lead and lead compounds, chemicals know to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling. 7 UNPACKING INSTRUCTIONS • • Remove all parts and packing materials from carton. ½" Wrench (2) 9 9 CONTAINER CONTENTS 3 - Soft Bag Containers 1 - Lower Chute 1 - Cover Assembly 1 - Catcher Mount 1 - Upper Chute 1 - Catcher Hitch 1 - Cast Weight Hardware TOOLS REQUIRED • • • • /16" Wrench /16" Socket wrench Drill and 5/16" bit PARTS IDENTIFICATION COVER ASSEMBLY UPPER CHUTE DUMP BAG INDICATOR CHUTE LATCH LOWER CHUTE BAG CONTAINERS NOTE: When right hand (RH) and left hand (LH. ) are mentioned in this manual, it means when seated on the mower in the operator’s position. CAUTION BEFORE ASSEMBLING GRASS CATCHER TO MOWER: • Place motion control levers in “NEUTRAL” position. • Make sure the blades and all moving parts have completely stopped. • Disconnect spark plug and place wire where it cannot come in contact with plug. 8 ASSEMBLY 1 BAGGER MOUNT - 2009 Models BAGGER SUPPORT -2008 and Prior Models Remove rear engine guard (if installed) by removing the six bolts that attach the guard to the frame. Engine Guard Bolts Rear Engine Guard Engine Guard Bolts 1. Install the bagger mount tube to the rear guard with 5/16-18 x 3¼ bolts and flange nuts from kit. NOTE: Depending on model, rear guard hole may need to be drilled out to 5/16" if kit hardware is too large. 2. Install kit support straps on the outside of the mount tube as shown in the illustration. Using a 5/16-18 x 1¼ bolt, attach the front side of the strap to the fender support. Secure with additional 1¼ bolt and fasten both bolts with flange nuts. NOTE: The front side of the kit support straps should be on the inside of the mower frame. Deflector Shield Center Support Tubes Deflector Bracket Tab 8063-009 WARNING DO NOT operate mower unless container is properly installed. Container is subject to wear and deterioration, check containers frequently, replace when cracked or damaged. Use only a recommended replacement container. 8063-038 Front Latch Rear Latch CAUTION CAUTION Before raising deflector shield, turn mower engine off. Raise and hold shield when attaching lower chute and allow it to rest on chute while in operation. 11 ASSEMBLY 7 UPPER CHUTE INSTALLATION 1. Attach bungee latch assembly from kit as illustrated. 8 CHUTE / HOOD INSTALLATION 1. Push upper chute through the gasketed opening in the cover assembly. [. . . ] • See BLADE CARE instructions in your mower operator’s manual. STORAGE When grass catcher is to be stored for a period of time, clean it thoroughly, remove all dirt, grass, leaves, etc. Store in a clean, dry place. CAUTION BEFORE PERFORMING MAINTENANCE, SERVICE OR ADJUSTMENTS: • Place motion control levers in “NEUTRAL” position. • Make sure blades and all moving parts have completely stopped. • Disconnect spark plug wire(s) from spark plug(s) and place wire where it cannot come in contact with plug. CAUTION Grass catcher components are subject to wear, damage and deterioration, which could expose moving parts or allow objects to be thrown. [. . . ]