User manual HUSQVARNA 924HV

[. . . ] Operator’s Manual 924HV Gasoline containing up to 10% ethanol (E10) is acceptable for use in this machine. The use of any gasoline exceeding 10% ethanol (E10) will void the product warranty. 532 44 34-65 Please read the owner's manual carefully and make sure you understand the instructions before using the machine. English Safe Operation Practices for Walk-Behind Snow Throwers This snow thrower is capable of amputating hands and feet and throwing objects. Failure to observe the following safety instructions could result in serious injury. WARNING: Always disconnect spark plug wire and place it where it cannot contact plug in order to prevent accidental starting when setting up, transporting, adjusting or making repairs. [. . . ] Empty the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur. ON / OFF SWITCH RECOIL (AUXILIARY) STARTER HANDLE GASOLINE FILLER CAP CHOKE CONTROL ENGINE OIL FILL CAP / DIPSTICK STARTER BUTTON SCRAPER BAR (See Fig. When it has worn almost to the edge of the housing, it can be reversed, providing additional service before requiring replacement. Replace a damaged or worn scraper bar. FUEL SHUT-OFF VALVE NOTE: ALL ITEMS ARE SHOWN IN THEIR TYPICAL LOCATION. 19) The engine on your snow thrower has been shipped from the factory already filled with oil. Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw tight, wait for a few seconds, remove and read oil level. ” • To change engine oil, see “TO CHANGE ENGINE OIL ” in the Maintenance section of this manual. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness. 12 TO START ENGINE • Be sure fuel shut-off valve is in the “OPEN” position. The electric starter is equipped with a three-wire power cord and plug and is designed to operate on 120 Volt A. C. WARNING: Do not use the electric starter if your house is not a 120 Volt A. C. Serious personal injury or damage to your snow thrower could result. OPERATION COLD START - ELECTRIC STARTER 1. Insert safety ignition key (tied to recoil start cord) into ignition slot until it clicks. Plug the other end of the power cord into a three-hole grounded 120 Volt A. C. NOTE: Do not use primer when starting engine with the electric starter. IMPORTANT: Do not crank engine more than five continuous seconds between each time you try to start. When the engine starts, release the starter button and slowly move the choke control to the “OFF” position. Disconnect the power cord from the receptacle first, then from the engine. Engine will not develop full power until it has reached normal operating temperature. WARM START - ELECTRIC STARTER Follow the steps above, keeping the choke control in the “OFF” position. Insert safety ignition key (tied to recoil start cord) into ignition slot until it clicks. [. . . ] If your engine does not operate properly due to suspected carburetor problems, take your snow thrower to a qualified service center. FIG. 24 18 STORAGE Immediately prepare your snow thrower for storage at the end of the season or if the unit will not be used for 30 days or more. WARNING: Never store the snow thrower with gasoline in the tank inside a building where fumes may reach an open flame, spark or pilot light as on a furnace, water heater, clothes dryer or gas appliance. • Empty the fuel tank by starting the engine and letting it run until the fuel lines and carburetor are empty. [. . . ]