User manual HUSQVARNA 600 H

[. . . ] Familiarize your-self with the machine before the first use and Also have yourself introduced to practical use of the machine. The manufacturer / supplier is not liable for any injury and/or damage arising from inappropriate use. Appropriate use of the machine also includes adherence to the operating instructions and compliance with the servicing and maintenance instructions. Always disconnect the plug from the mains socket before carrying out any work on the equipment, before cleaning and before moving the equipment. [. . . ] Ensure that the motor of your hedge shears can not be switched on by mistake when you put it down after work or when you are going to clean the device. Check the cutting unit regularly for damage and if damage is discovered, the cutting unit should be properly repaired. Be aware of your responsibility as user towards third parties in the working area. These flexes must not be lighter than PVC covered flex conforming to 227 IEC 53. Damaged cables of this unit are only to be replaced by a service station designated by the manufacturer as special tools are necessary. Equipment which will be used in different outside loca-tions should be connected via residualcurrent - operated current breakers. Ensure that the equipment is stored safely after use in such a way that the blade cannot be touched. When using the equipment, hold it securely with both hands, stand firmly and ensure that you have sufficient working space. There should be no people, animals or objects within the working area. Select the cutting height so that the blade does not make contact with the ground and you can operate the equipment from a secure position. For initial use of the hedge trimmer we would recommend that in addition to reading the operating instructions, you also seek a practical demonstration from an expert. The 5 special features two-hand safety switch, quick blade stop, protective cover, blade safety rail and impact protector are fitted to provide the hedge trimmer with optimum safety features. Quick blade stop In order to avoid injuries through cuts, the blade will stop in max. 9) The cutting blade set back from the blade housing reduces the risk of injuries due to unintentional body contact. As soon as the hedge trimmer is switched off, the sharp cutting blades will stop - due to safety reasons - exactly under the cover rail in order to reduce the risk of injuries during transport. 11) The extended guide rail prevents unpleasant shocks (blade recoil) being transmitted to the operator due to impact with solid objects (wall, ground etc. Gear protection feature If solid objecst are caught in the cutting blade and jam the motor, switch off the machine at once, disconnect the power plug from the power socket, remove the object and continue with the work. The equipment is also fitted with an overload cutout, which protects the gears against mechanical damage in the event of blade jams. Always disconnect the plug from the power socket before commencing any work on the machine. Important: Always clean and oil the blades after prolonged use of the hedge trimmer. Clean the shearing blades with a dry cloth or ­ in case of heavier dirt ­ with a brush. Oiling of the blades should ideally be carried out using an environmentally friendly lubricant (Fig. [. . . ] 10) This equipment will enable you to cut or trim bushes and hedges easily and comfortably. Branches, which are too thick for the hedge trimmer, should be cut with a saw. In order to achieve an even height Fix a guide line at the required height. Repairs to electric power tools should only be carried out by specialist electrical personnnel. [. . . ]