User manual HUSQVARNA 525RX

[. . . ] Operator’s manual Manuel d’utilisation Manual de instrucciones 525RX 525RXT 525RK Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. Careless or incorrect use can result in serious or fatal injury to the operator or others. Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. Always wear: • • • Wear a protective helmet where there is a risk of falling objects Approved hearing protection Approved eye protection Other symbols/decals on the machine refer to special certification requirements for certain markets. [. . . ] € • • • • • • Do not mix more than one month’s supply of fuel at a time. If the machine is not used for some time the fuel tank should be emptied and cleaned. Ensure that the fuel is well mixed by shaking the container before filling the tank. Be aware of the fire hazard, especially when working near flammable substances and/ or vapors. Com manuals search engine English – 17 STARTING AND STOPPING Check before starting Starting and stopping Check the blade to ensure that no cracks have formed at the bottom of the teeth or by the centre hole. The most common reason why cracks are formed is that sharp corners have been formed at the bottom of the teeth while sharpening or that the blade has been used with dull teeth. The complete clutch cover and shaft must be fitted before the machine is started, otherwise the clutch can come loose and cause personal injury. Always move the machine away from the refueling area and source before starting. Ensure the cutting attachment cannot come into contact with any object. € Check that the support flange is not cracked due to fatigue or due to being tightened too much. Make sure no unauthorised persons are in the working area, otherwise there is a risk of serious personal injury. Starting Cold engine (1) Air purge: Press the air purge repeatedly until fuel begins to fill the bulb. € Check that the trimmer head and trimmer guard are not damaged or cracked. Replace the trimmer head or trimmer guard if they have been exposed to impact or are cracked. € • Never use the machine without a guard nor with a defective guard. All covers must be correctly fitted and undamaged before you start the machine. When the engine is started with the choke in either the choke or start throttle positions the cutting attachment will start to rotate immediately. No 1 2015-06-15 STARTING AND STOPPING Hold the body of the machine on the ground using your left hand (CAUTION!(3) Grip the starter handle, slowly pull out the cord with your right hand until you feel some resistance (the starter pawls grip), now quickly and powerfully pull the cord. Never wrap the starter cord around your hand Repeat pulling the cord until engine attemps to start (or maximum 5 pulls). (5) Pull the cord until engine starts and gradually operate throttle trigger for increasing engine speed to operate speed. Warm engine (1) Air purge: Press the air purge repeatedly until fuel begins to fill the bulb. [. . . ] A statement in such written instructions to the effect of ”repair or replace as necessary” will not reduce the period of warranty coverage. Any such part repaired or replaced under warranty will be warranted for the remaining warranty period. mANUFACTURER′S WARRANTY COVERAGE The emissions control system is warranted for two years. If any emissions-related part on your small off-road engine is defective, the part will be repaired or replaced by Husqvarna Forest & Garden. [. . . ]