User manual HUSQVARNA 4210G

[. . . ] 2008 HUV4210 Owner’s Manual Electric and Gasoline Utility Vehicles: HUV4210-G, HUV4210-E, HUV4210-GXP, and HUV4210-EXP NOTICE Warranty information appears on the last pages of this manual. Please complete and return the warranty registration card included in this manual. Husqvarna is not liable for errors in this manual or for incidental or consequential damages that result from the use of the material in this manual. This manual contains proprietary information that is protected by copyright. [. . . ] Let the terminals dry and then coat them with Battery Terminal Protector Spray (Husqvarna 603 00 00-03). 3 1 2 1. Open (ON) NOTE: When selecting valve position, ensure that it is fully opened or fully closed. 449 Figure 17 Fuel Shut-off Valve 2008 HUV4210 Owner’s Manual Page 29 Maintenance 5. To protect the engine, remove spark plug and pour 1/2 ounce (14. 2 mL) of SAE 10 weight oil into the engine through the spark plug hole. Rotate engine crankshaft by hand several times, then install the spark plug and tighten to 20 ft-lb (27 N·m). Thoroughly clean front body, rear body, seats, engine compartment, and underside of vehicle. Connect battery cables, positive (+) cable first, and tighten terminals to 144 in-lb (16 N·m). A partially closed fuel shut-off valve combined with the use of the choke can result in a fouled spark plug and engine failure. Crank the engine until fuel is pumped into the carburetor and fuel lines and the engine starts. See following NOTE. NOTE: Due to the oil added to the engine in preparation for storage, engine may smoke excessively for a short time when it is run for the first time after storage. Perform the Pre-Operation and Daily Safety Checklist on page 20. MAINTENANCE See General Warnings on page 10. To ensure trouble-free vehicle performance, it is very important to follow an established preventive maintenance program. Regular and consistent vehicle maintenance can prevent vehicle downtime and expensive repairs that can result from neglect. Use the Pre-Operation and Daily Safety Checklist on page 20 and the following Periodic Service Schedules and Periodic Lubrication Schedules to keep the vehicle in proper working condition. Any vehicle not functioning correctly should be removed from use until it is properly repaired. This will prevent further damage to the vehicle and avoid the possibility of injury due to unsafe conditions. Contact your local Husqvarna distributor/dealer to perform all repairs and semiannual and annual periodic service. WARNING • If any problems are found during scheduled inspection or service, do not operate the vehicle until repairs are made. Failure to make necessary repairs could result in fire, property damage, severe personal injury, or death. • Only trained technicians should service or repair the vehicle or battery charger. Anyone doing even simple repairs or service should have knowledge and experience in electrical and mechanical repair. The appropriate instructions must be used when performing maintenance, service, or accessory installation. Electric vehicles: WARNING CONTINUED ON NEXT PAGE Page 30 2008 HUV4210 Owner’s Manual Periodic Service Schedules WARNING • Hot!• To avoid unintentionally starting the vehicle, disconnect the batteries as shown (Figure 3). [. . . ] (3) Any warranted part that is scheduled for replacement as required maintenance in the written instructions supplied is warranted for the period of time before the first scheduled replacement date for that part. If the part fails before the first scheduled replacement, the part will be repaired or replaced by Husqvarna according to subsection (4) below. Any such part repaired or replaced under warranty will be warranted for the remainder of the period prior to the first scheduled replacement point for the part. (4) Repair or replacement of any warranted part under the warranty provisions herein must be performed at a warranty station* at no charge to the owner. Page 56 2008 HUV4210 Owner’s Manual Warranties (5) Notwithstanding the provisions herein, warranty services or repairs will be provided at all of our distribution centers that are franchised to service the subject engines or equipment. [. . . ]