User manual HUSQVARNA 345 E EPA III

[. . . ] Operator’s manual 345e EPA III 346XP EPA I 353 EPA III TrioBrake Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. English KEY TO SYMBOLS Symbols on the machine: WARNING!Careless or improper use can result in serious or fatal injury to the operator or others. Symbols in the operator’s manual: Switch off the engine by moving the stop switch to the STOP position before carrying out any checks or maintenance. Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. Always wear: • Approved protective helmet • Approved hearing protection • Protective goggles or a visor Both of the operator′s hands must be used to operate the chain saw. Always wear approved protective gloves. Regular cleaning is required. Visual check. Never operate a chain saw holding it with one hand only. Kickback may occur when the nose or tip of the guide bar touches an object, and cause a lightning fast reverse reaction, kicking the guide bar up and towards the operator. [. . . ] Once the machine has Push in the choke control as soon as the engine fires and make repeated starting attempts. As the chain brake is still activated the engine must return to idling speed as soon as possible by disengaging the throttle English – 21 STARTING AND STOPPING latch in order to avoid unnecessery wear on the clutch assembly. • Observe your surroundings and make sure that there is no risk of people or animals coming into contact with the cutting equipment. Note!Long term inhalation of the engine’s exhaust fumes, chain oil mist and dust from sawdust can represent a health risk. Always hold the saw with both hands. The right hand should be on the rear handle, and the left hand on the front handle. Use a firm grip with thumbs and fingers encircling the chain saw handles. Never start a chain saw unless the bar, chain and all covers are fitted correctly. Without a bar and chain attached to the chain saw the clutch can come loose and cause serious injury. Stopping • The chain brake should be activated when starting. This method is very dangerous because you may lose control of the saw. The engine is stopped by pushing the stop switch to the stop position. Exhaust fumes can be dangerous if inhaled. 22 – English WORKING TECHNIQUES Before use: 5 4 3 6 7 8 Basic safety rules 1 • • Look around you: To ensure that people, animals or other things cannot affect your control of the machine. To make sure that none of the above might come within reach of your saw or be injured by falling trees. 2 1 2 3 4 5 6 7 8 9 1 9 10 Check that the chain brake works correctly and is not damaged. Check that all parts of the chain saw are tightened correctly and that they are not damaged or missing. Replace it if necessary with an aluminium chain catcher (is available as spare part). Follow the instructions above, but do not use a chain saw in a situation where you cannot call for help in case of an accident. 2 Do not use the machine in bad weather, such as dense fog, heavy rain, strong wind, intense cold, etc. Working in bad weather is tiring and often brings added risks, such as icy ground, unpredictable felling direction, etc. Take great care when removing small branches and avoid cutting bushes (i. e. Small branches can be grabbed by the chain and thrown back at you, causing serious injury. 10 Check the chain tension. General working instructions IMPORTANT!This information is never a substitute for professional skills and experience. If you get into a situation where you feel unsafe, stop and seek expert advice. Contact your chain saw dealer, service agent or an experienced chain saw user. Before using a chain saw you must understand the effects of kickback and how to avoid them. Before using a chain saw you must understand the difference between cutting with the top and bottom edges of the bar. [. . . ] Serious injury to the operator, helpers, bystanders or any combination of these persons may result from one-handed operation. A chain saw is intended for twohanded use. With a basic understanding of kickback, you can reduce or eliminate the element of surprise. Keep a good firm grip on the saw with both hands, the right hand on the rear handle, and the left hand on the front handle, when the engine is running. Use a firm grip with thumbs and fingers encircling the chain saw handles. [. . . ]