User manual HUSQVARNA 225 H60

[. . . ] Operator's manual (EPA) 225H60 225H75 Please read these instructions carefully and make sure you understand them before using the machine. English SYMBOL EXPLANATION Symbols WARNING!Checks and/or maintenance should be carried out with the engine switched off, with the stop switch in the STOP position. Always use approved protective gloves. Read through the Operator‘s Manual carefully and understand the content before using the hedge trimmer. Regular cleaning required. Always use • Ear protection • Approved eye protection • This product is in accordance with applicable EC directives. Ocular control. • Always wear approved protective gloves. Approved eye protection must always be used. • Cutting tool. [. . . ] When the handle is adjusted the hedge trimmer should be idling or not running. • While working the handle should always be facing upwards irrespective of how the hedge trimmer is directed. • When trimming a hedge the engine should always be turned away from the hedge. • The hedge trimmer should be held as close to the body as possible to get the best balance. • Do not try to force the work, but move at a steady speed so that all the stems are cut evenly. 10 – English WHAT IS WHAT? 1 2 23 4 5 6 7 3 8 9 20 18 17 16 24 15 14 21 22 13 12 11 10 What is what on the hedge trimmer? 1. Operator’s Manual Grease filler cap Gearbox Blades Blade guard Loop handle Cylinder cover Starter handle Stop switch Throttle trigger lock Adjustable handle Lock for handle 13. Throttle trigger Fuel tank Fuel cap Air filter cover Choke Hand guard Tube of grease Allen key Spark plug spanner 23. Air purge English – 11 FUEL HANDLING Fuel mixture NOTE!The machine is fitted with a two-stroke engine and must always be run on a mixture of gasoline and two-stroke oil. It is important to measure the quantity of oil accurately, to ensure the correct mixture ratio. Small discrepancies in the amount of oil have a great bearing on the proportions of the fuel mixture when mixing small amounts of fuel. Mixture • Always mix gasoline and oil in a clean container intended for fuel. • Always start by filling half the quantity of gasoline required. • Mix (shake) the fuel mixture carefully before filling in the machine‘s fuel tank. • If the machine is not used for a long period of time, the fuel tank should be emptied and cleaned. • This engine is certified to operate on unleaded gasoline. ! WARNING!Always provide good ventilation when handling fuel. Gasoline NOTE!If your machine is equipped with a catalytic converter, ( an unleaded, oil mixed quality gasoline should always be used. If you run the engine on lower octane rating than 87 socalled “knocking“ can occur. This leads to an increased engine temperature, which can result in a serious engine breakdown. • When working at continuous high revs a higher octane rating is recommended. !Be aware of the fire hazard, especially when handling the saw near flammable substances or vapours. Fuelling WARNING!The following precautions reduce the risk of fire: Do not smoke or place any sources of heat in the vicinity of the fuel. [. . . ] to EN ISO 11806 and ISO 7917, dB(A): Vibration levels Vibration levels on the handles measured acc. speed , rear/front handles: Blades Type: Length, mm: Blade speed, Cut/min: 225H60 1, 55/25, 4 1, 34/34 1, 10/28 2 700 11 000-11 700 0, 9 kW/ 9 000 rpm Yes Yes 225H75 1, 55/25, 4 1, 34/34 1, 10/28 2 700 11 000-11 700 0, 9 kW/ 9 000 rpm Yes Yes Walbro MB/CD Champion RCJ 7Y 0, 02/0, 5 Walbro MB/CD Champion RCJ 7Y 0, 02/0, 5 Walbro WT 0, 85/0, 4 Walbro WT 0, 85/0, 4 12, 1/5, 5 12, 6/5, 7 95, 1 95, 1 2, 3/2, 0 3, 0/2, 3 2, 2/1, 5 2, 2/1, 5 Double sided 600 2 480 Double sided 750 2 480 Note 1: Equivalent sound pressure level is calculated as the time-weighted energy total for sound pressure levels under various working conditions with the following time distribution: 1/2 idle and 1/2 max. speed. 18 – English ´+H'o¶5:¨ EMISSION CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONS The EPA (The US Environmental Protection Agency), Environment Canada and Husqvarna Forest & Garden are pleased to explain the emissions control system warranty on your 2001 and later small nonroad engine. and Canada, new small nonroad engines must be designed, built and equipped to meet the federal stringent anti-smog standards. [. . . ]