User manual HUSQVARNA 128L

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual HUSQVARNA 128L. We hope that this HUSQVARNA 128L user guide will be useful to you.


HUSQVARNA 128L : Download the complete user guide (462 Ko)

You may also download the following manuals related to this product:

   HUSQVARNA 128L (700 ko)

Manual abstract: user guide HUSQVARNA 128L

Detailed instructions for use are in the User's Guide.

[. . . ] SERVICE 545196750 OM, 128L/C , 2009-02, 545196750 128 L, 128 C 545 19 67-50 CONTENTS Contents CONTENTS Contents . 5 Checking, maintaining and servicing the machine’s safety equipment . 23 Husqvarna AB has a policy of continuous product development and therefore reserves the right to modify the design and appearance of products without prior notice. Long-term exposure to noise can result in permanent hearing impairment. [. . . ] The bevel gear can get hot during use and may remain so for a while afterwards. Children, animals, onlookers and helpers should be kept outside the safety zone of 50 feet (15 meters). Stop the machine immediately if anyone approaches. S When cutting and sweeping you should use full throttle to obtain the best results. 545196750 Rev. 3 2/17/09 English--- 11 KNOW YOUR TRIMMER 1 2 3 128L 6 8 4 5 16 1 9 10 11 128C 7 15 13 14 12 4 1 17 18 Know your trimmer 1. Starter handle Fuel tank Choke control Primer bulb Air filter cover Handle adjustment Drive disc 2-stroke engine oil Operator’s manual (EPA) 19 545196750 Rev. 3 2/17/09 English--- 12 ASSEMBLY NOTE: Make sure unit is assembled correctly as shown in this manual. Fitting the trimmer guard and trimmer head (Model 128C) Fitting the loop handle S Position the handle on the shaft. Note that the handle must be mounted between the two arrows on the shaft. S Fit the correct trimmer guard (A) for use with the trimmer head. Hook the trimmer guard/combination guard onto the fitting on the shaft and secure with the wing nut (B). B A S Fit the screw, securing plate and wing nut as shown in the diagram. S Screw the trimmer head (D) onto the shaft. Fitting the trimmer guard and trimmer head (Model 128L) S Fit the correct trimmer guard (A) for use with the trimmer head. Hook the trimmer guard/combination guard onto the fitting on the shaft and secure with the bolt (D). D B C D S To dismantle, follow the instructions in the reverse order. S Turn the shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing. S Screw on the trimmer head (H) in the opposite direction to the direction of rotation. The machine is equipped with a two-stroke engine and must always be run using a mixture of gasoline and twostroke engine oil. It is important to accurately measure the amount of oil to be mixed to ensure that the correct mixture is obtained. When mixing small amounts of fuel, even small inaccuracies can drastically affect the ratio of the mixture. S Mix (shake) the fuel mixture thoroughly before filling the machine’s fuel tank. WARNING: Always ensure there is adequate ventilation when handling fuel. Gasoline S Do not mix more than one month’s supply of fuel at a time. S If the machine is not used for some time, the fuel tank should be emptied and cleaned. WARNING: The catalytic converter muffler gets very hot during and after use. Be aware of the fire hazard, especially when working near flammable substances and/or vapors. CAUTION! [. . . ] Proof of purchase, as explained in Section 6, rests solely with the customer. SECTION 4: EXCEPTIONS AND LIMITATIONS It is the Owner’s and Dealer’s responsibility to make certain that the Warranty Registration Card is properly filled out and mailed to Husqvarna. This card should be mailed within ten (10) days from the date of purchase in order to confirm the warranty and to facilitate postsale service. Proof of purchase must be presented to the authorized Husqvarna dealer in order to obtain warranty service. This proof must include date purchased, model number, serial number, and complete name and address of the selling dealer. To obtain the benefit of this warranty, the product believed to be defective must be delivered to an authorized Husqvarna dealer in a timely manner, no later than thirty (30) days from date of the operational problem or failure. An authorized Husqvarna dealer can be normally located through the “Yellow Pages” of the local telephone directory or by calling 1-800-438-7297 for a dealer in your area. 7349 Statesville Road CHARLOTTE, NC 28269 English--- 22 U. S. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE HUSQVARNA 128L




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual HUSQVARNA 128L will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.