User manual HUSQVARNA (2007

[. . . ] 2007 Utility Vehicles Gasoline and Diesel Owner’s Manual HUV 4421-G / GXP HUV 4421-D / DXP NOTICE Warranty information appears on the last pages of this manual. Your authorized representative checked the vehicle before it was delivered to you and will provide you a copy of the completed vehicle warranty registration form. Husqvarna is not liable for errors in this manual or for incidental or consequential damages that result from the use of the material in this manual. This manual contains proprietary information that is protected by copyright. [. . . ] Wash the battery top and terminals with a solution of baking soda and water (1 cup (237 mL) baking soda per 1 gallon (3. 8 L) of water). Let the terminals dry and then coat them with Battery Terminal Protector Spray (P/N 603 00 00-03). Thoroughly clean the front body, rear body, seats, cargo bed, engine compartment, and underside of vehicle. Chock the wheels to prevent the vehicle from rolling. RETURNING THE STORED VEHICLE TO SERVICE 1. Make sure the key switch is in the OFF position and the Forward/Reverse handle is in the NEUTRAL position. Restore the fuel system to operation (Figure 36 or Figure 37, Page 44). Connect the battery cables, positive (+) cable first, and tighten the terminals to 144 in-lb (16 N·m). Coat terminals with Battery Terminal Protector Spray (P/N 603 00 00-03). Gasoline vehicles only: Completely open the fuel shut-off valve (Figure 12, Page 26). A partially closed fuel shut-off valve combined with the use of the choke can result in a fouled spark plug and engine failure (Figure 13, Page 26). 2007 HUV 4421 Gasoline and Diesel Vehicle Owner’s Manual Page 27 Maintenance 5. Crank the engine until fuel is pumped into the carburetor (gasoline vehicles) and the fuel lines (all vehicles) and the engine starts. NOTE: Due to the oil added to the gasoline engine in preparation for storage, the engine may smoke excessively for a short time when it is run for the first time after storage. Perform the Pre-Operation and Daily Safety Checklist on page 17 and the Performance Inspection on page 18. MAINTENANCE See General Warnings on page 8. To ensure trouble-free vehicle performance, follow an established preventive maintenance program. Regular and consistent maintenance can prevent vehicle downtime and expensive repairs. Use the Pre-Operation and Daily Safety Checklist on page 17, the Performance Inspection on page 18, and the following Periodic Service Schedule and Periodic Lubrication Schedule to keep the vehicle in proper working condition. Any vehicle not functioning correctly should not be used until it is properly repaired. This will prevent further damage to the vehicle and help prevent injury to occupants resulting from unsafe conditions. Contact your local dealer/distributor for repairs and semiannual and annual periodic service. ý WARNING • Only trained technicians should service or repair the vehicle. Anyone doing even simple repairs or service should have knowledge and experience in electrical and mechanical repair. The appropriate instructions must be used when performing maintenance, service, or accessory installation. • If any problems are found during scheduled inspection or service, do not operate vehicle until repairs are made. [. . . ] (3) Any warranted part that is scheduled for replacement as required maintenance in the written instructions supplied is warranted for the period of time before the first scheduled replacement date for that part. If the part fails before the first scheduled replacement, the part will be repaired or replaced by CLUB CAR according to subsection (4) below. Any such part repaired or replaced under warranty will be warranted for the remainder of the period prior to the first scheduled replacement point for the part. (4) Repair or replacement of any warranted part under the warranty provisions herein must be performed at a warranty station* at no charge to the owner. [. . . ]