User manual HUSKY LINERS 9532

[. . . ] CARPET LINER CARE AND USE INSTRUCTIONS Your new 3D® carpet liners are custom molded to fit your vehicle. For the correct fit, it is necessary to remove the factory floor mats before installing your new carpet liners. [. . . ] Your 3D® carpet liners come with a lifetime warranty against tearing and cracking. For warranty information or to see other products we have available for your vehicle, please see our web site, http://www. huskyliners. com. ALIGNMENT VIEW SHOWING PLACEMENT OF YOUR TOYOTA SEQUOIA/TOYOTA TUNDRA HUSKY 3D CARPET FRONT FLOOR LINERS DRIVER'S SIDE PASSENGER'S SIDE 9532_Insert X 2. doc 06/16/03 CARPET LINER INSTALLATION INSTRUCTIONS Your new 3D® Carpet Liners are designed to be held firmly in place with a Velcro® anchoring system. You will find that each of your front liners come with two Velcro® "hook" patches applied to the underneath surface of the liners. In the hardware bag included in the shipping container you will find 4 anchor screws with the "loop" portion of the Velcro® applied. The anchor screws will need to be installed in your factory carpet directly beneath the Velcro® hook patches to hold the liners in place. The anchor screws will not damage your carpet and can easily be removed if necessary. To align the anchors with the patches on the liner, first place your liner in the vehicle, adjusting it to the proper fit. Then, pull up a corner of your liner as shown in the photo below and attach the anchor screw to the Velcro® pad on the liner. Lower the raised edge and note the position where the anchor screw touches the vehicle carpet. There are many ways to mark this location; here are a couple of suggestions: ·Apply a 1" strip of masking tape directly to the carpet underneath the anchor screw. [. . . ] Carefully apply pressure and twist to release the clip (pushing from the firewall towards the seat). Velcro® Dot on back of liner. Anchor screw shown attached to Velcro® Dot on back of liner. Anchor screw will pierce masking tape, marking screw location. With screw secured in carpet, align Velcro® halves to secure liner in place. 9532_Insert X 2. doc 06/16/03 [. . . ]