User manual HUSKY LINERS 9180

[. . . ] CARPET LINER CARE AND USE INSTRUCTIONS Your new 3D® carpet liners are custom molded to fit your vehicle. For the correct fit, it is necessary to remove the factory floor mats before installing your new carpet liners. [. . . ] Do not use solvent-based cleaners or cleaners containing bleach as these may discolor your carpet. Your 3D® carpet liners come with a lifetime warranty against tearing and cracking. For warranty information or to see other products we have available for your vehicle, please see our web site, http://www. huskyliners. com. ALIGNMENT VIEW SHOWING PLACEMENT OF YOUR REAR SEAT 3D CARPET FLOOR LINER IN A FORD F-150 SUPER CREW TRUCK FRONT OF VEHICLE PART NUMBER MOLDED ON BACK SIDE OF LINER THIS PART IS DESIGNED FOR THE `NEW" BODY STYLE OF FORD F-150 INTRODUCED IN 2004. IT WILL NOT FIT THE PREVIOUS GENERATION (2001-2003) FORD F-150 SUPER CREW'S WHICH REQUIRE PART #9176. 9180_Insert X 2. doc 07/24/2004 CARPET LINER INSTALLATION INSTRUCTIONS Your new 3D® Carpet Liners are designed to be held firmly in place with a Velcro® anchoring system. You will find that your second seat liner comes with two Velcro® "hook" patches applied to the underneath surface of the liner. In the hardware bag included in the shipping container you will find 2 anchor screws with the "loop" portion of the Velcro® applied. The anchor screws will need to be installed in your factory carpet directly beneath the Velcro® hook patches to hold the liners in place. The anchor screws will not damage your carpet and can easily be removed if necessary. To align the anchors with the patches on the liner, first place your liner in the vehicle, adjusting it to the proper fit. Then, pull up a corner of your liner as shown in the photo below and attach the anchor screw to the Velcro® pad on the liner. [. . . ] ·Insert a straight pin (needle) next to the point where the anchor screw contacts the carpet to mark the screw location. Velcro® Dot on back of liner. Anchor screw shown attached to Velcro® Dot on back of liner. Anchor screw will pierce masking tape, marking screw location. With screw secured in carpet, align Velcro® halves to secure liner in place. 9180_Insert X 2. doc 07/24/2004 [. . . ]