User manual HUMMINBIRD TROLLING MOTOR MOUNTED TRANSDUCER

[. . . ] The trolling motor mounted transducer allows you to gather sonar information from the point on the boat closest to where you are fishing. It is important that you properly orient the transducer housing in the direction of travel of the trolling motor, to ensure an accurate depiction of the terrain under your boat. The trolling motor mounted transducer will fit any standard trolling motor housing. Some users install this transducer in conjunction with a switch so that the standard transducer can be used for high-speed operation, and the trolling motor transducer can be used while trolling. 1. [. . . ] Connecting the Cable Insert the transducer cable into the appropriate terminal slot. The cable connectors are labeled, and there are corresponding labels on the cable holder on the rear of the control head. The slots are keyed to prevent reversed installation, so be careful not to force the connector into the holder. 4. Test and Finish the Installation When you have installed both the control head and the trolling motor transducer, and have routed all the cables, you must perform a final test to verify installation. Testing should be performed with the boat in the water, although you can initially confirm basic operation with the boat out of the water. NOTE: Make sure the trolling motor is re-connected to the power source before performing this procedure. 1. If the unit does not power-up, make sure that the connector holder is fully seated in the receptacle and that power is available. If all connections are correct and power is available, the Humminbird® control head will enter Normal operation. NOTE: The transducer must be submerged in water for reliable transducer detection. 3. Make sure that the boat is in water greater than 2' but less than the depth capability of the unit, and that the transducer is fully submerged, since the sonar signal cannot pass through air. If the bottom is visible on-screen with a digital depth readout, the unit is working properly. All rights reserved. 3 Trolling Motor Mounted Transducer Maintenance If your boat remains in the water for long periods of time, algae and other marine growth can reduce the effectiveness of the transducer. If your boat remains out of the water for a long period of time, it may take some time to wet the transducer after it is returned to the water. Small air bubbles can cling to the surface of the transducer and interfere with proper operation. These bubbles will dissipate with time, or you may wipe the face of the transducer with your fingers after the transducer is in the water. 530511-2_C Humminbird® Service Policy Even though you'll probably never need to take advantage of our incredible service policy, it's good to know that we back our products this confidently. We will make every effort to repair your unit within three business days from the receipt of your unit at our factory. Units received on Friday are typically shipped by the following Wednesday, units received Monday are typically shipped by Thursday, etc. All repair work is performed by factory-trained technicians to meet exacting factory specifications. Factory-serviced units go through the same rigorous testing and quality control inspections as new production units. After the original warranty period, a standard flat rate service charge will be assessed for each repair (physical damage and missing parts are not included). Any repairs made after the original warranty will be warranted for an additional 90 days after service has been performed by our factory technicians. You can contact our Customer Resource Center or visit our web site to verify the flat rate repair fee for your product (visit the Product Support section): http://www. humminbird. com We reserve the right to deem any product unserviceable when replacement parts are no longer available or impossible to obtain. This applies only to Humminbird® products returned to our factory in Eufaula, Alabama. This Service Policy is subject to change without notice. DOMESTIC (USA) CUSTOMERS: PLEASE DO NOT RETURN THIS PRODUCT TO STORE FOR SERVICE For all technical issues please call 1-800-633-1468 or visit www. humminbird. com, click SUPPORT. [. . . ] Disassembly and repair of this electronic unit should only be performed by authorized service personnel. Any modification of the serial number or attempt to repair the original equipment or accessories by unauthorized individuals will void the warranty. This product contains chemicals known to the State of California to cause cancer and/or reproductive harm. · Tag product with your name, street address, phone number and your assigned Repair Authorization Number. [. . . ]