User manual HUMMINBIRD TEMPERATURE SPEED ACCESSORY INSTALLATION GUIDE

[. . . ] Temperature/Speed Accessory THANK YOU Thank you for choosing Humminbird, America's #1 name in depthsounders. Humminbird has built its reputation by manufacturing top-quality, thoroughly reliable marine equipment. Genuine Humminbird accessories offer the opportunity to upgrade and expand the capabilities of your Humminbird product. The Temperature/Speed accessory incorporates a paddlewheel-type speed sensor and a water temperature probe in a high-impact plastic housing. [. . . ] Probe Module Seal the mounting holes with marine-grade silicone Paddlewheel sealant, and attach the module to the transom using the two washers and two screws provided. Wood screw Figure 1 and washer INSTALLATION pn530523-1r91219F You may route the cable over the top of the transom, or drill a /" (16 mm) diameter hole in the transom directly above the module and above the waterline to route cable through. Use the cable clamps provided to secure the cable to the transom of the boat. If a throughhole is used, an escutcheon plate is included to dress the hole. Note: On fiberglass hulls, it is best to start with a smaller bit and use progressively larger drill bits to reduce the chance of chipping or flaking the outer coating. All mounting screws require a /" pilot hole drilled approximately /" deep. Additionally, seal any hole drilled in the transom of the boat with marine-grade silicone sealant (not included). Route the cable to your Control Head, and install the connector in the appropriate slot. Use the connector designated for accessories (labeled A) on the Control Head. Note: Refer to your Control Head installation guide for more information about the quick disconnect connector included with your Control Head. If the connections are correct, the Control Head will begin displaying water temperature and boat speed information immediately. If the speed sensor ROUTING CABLE THE fails to read properly at high speeds, adjust the height of the module on the transom. Rotating Retaining Axial Clip to Remove Paddlewheel. Figure 2 You should periodically CLEANING remove the paddlewheel from the housing and clean it to remove growth resulting from the marine environment, as a clean paddlewheel results in more accurate readings. Note: This procedure should only be performed when the boat is not running, and is normally performed when the boat is out of the water. Clean the paddlewheel by disengaging the axial clip from the housing wedge and rotating it forward. Once you have rotated the axial clip, remove it from the housing by sliding it away from the holes in the housing. [. . . ] Any modification of the serial number or attempt to repair the original equipment or accessories by unauthorized individuals will void the warranty. Handling and/or opening this unit may result in exposure to lead, in the form of solder. WARNING: This product contains lead, a chemical known to the State of California to cause cancer and birth defects and other reproductive harm. [. . . ]