User manual HUMMINBIRD 385CI COMBO KAYAK

[. . . ] Using needle-nose pliers, break out the tabs on the rear of the mounting base (Figure 6). Place the hole cover over the mounting surface hole, then use it to mark the position of the two mounting screws. Remove the Hole Cover, drill the two mounting holes using a 9/64" (3. 5 mm) bit, fill them with marine-grade silicone, then replace the Hole Cover and insert the #8 Phillips countersink wood screws. [. . . ] Contact the Humminbird® Customer Resource Center in any of the following ways: By Telephone: (Monday - Friday 8:00 a. Consider the following to determine the best location: · To check the location planned for the control head, test run the cables for the transducer, power, and optional-purchase Temp/Speed accessory (if applicable). There are two ways to route the cables to the unit: through a hole in the mounting surface underneath the mounting bracket, or from a hole outside the mounting bracket. Routing the cables under the mounting bracket provides maximum weather protection; this may not be feasible, however, if the area under the control head is inaccessible. In this case, route the cables through a hole at another location and cover with the supplied hole cover. ⷠThe mounting surface should be stable enough to protect the control head from excessive wave shock and vibration, and should provide visibility while in operation. ⷠThe mounting area should allow sufficient room for the unit to pivot and swivel freely, and for easy removal and installation (Figures 1 and 2). You must first determine the best location to mount the kayak transducer (Figure 7). ⷠSelect a location inside the hull, in the center, lower part of the kayak, in which the area forward of this location is smooth, flat, and free of protrusions or ribs. ⷠThe transducer should be mounted parallel to the water line so that it points straight down. ⷠSelect a location that will allow the transducer cable to easily connect to the control head. Charge the battery, using the included battery charger, until it is fully charged. Charging usually requires 8 continuous hours but may vary depending on your configuration. The LED on the charger will turn green when the battery is fully charged. When this happens, the battery is still charging properly and should be left to charge until the LED becomes green. (typically we respond to your e-mail within three business days): cservice@johnsonoutdoors. Do not pull on the battery or charger cables when you are trying to connect them to or disconnect them from the battery terminals. If the connector feels tight, use a slight wiggling motion to slide the spade connector into place on the terminal (Figure 12). Once you have installed the control head, transducer, and power, and have routed all the cables, you should perform a final test. If the unit does not power up, make sure that the connector holder is fully seated in the receptacle and that power is available. Prepare the mounting area and secure the transducer using the following procedures. The scuffed area should extend beyond the edges of the transducer bracket (included) when it is applied in the following steps. [. . . ] It is our goal to comply in the collection, treatment, recovery, and environmentally sound disposal of those products; however, these requirements do vary within European Union member states. For more information about where you should dispose of your waste equipment for recycling and recovery and/or your European Union member state requirements, please contact your dealer or distributor from which your product was purchased. If the cables must pass through a hole directly beneath the mounting bracket, mark and drill an additional 1" hole centered between the four mounting holes (Figure 3). Route the cables through the grommet, then press the grommet in place around the cables and into the 1" hole. [. . . ]