User manual HUBBELL LIGHTING SLS-2 CIRCUIT BALLAST

[. . . ] INSTALLATION INSTRUCTIONS FOR SLS TWO CIRCUIT REMOTE BALLAST SYSTEM Catalog Logic: R E M D - X X X X H X - XX - XX Fixture Watts: 1000 1500 1650 Fixture Voltage: (2) 208v (3) 240v (4) 277v (5) 480v Circuit No. [. . . ] 3/8" 3" 41" 5" 4-7/8" COUPLING W/ 3/4-10 INTERNAL THREADS FOR 3/4" BOLT FIGURE 1 4 3 2 © This ballast enclosure should be installed at a minimum height of 10 feet (3 meters) above grade. Enclosure Installation (Figures 1, 2, & 3) Important: Installation requires the use of a pole equipped with mounting couplings and wireway. Apply gasket to the back of enclosure around the 2-1/2" x 4-1/2" (63. 5mm x 114. 3mm) hole. (Figure 2) Leave 1" (25. 4mm) of thread exposed. 2 3 5 FIGURE 2 268-1220-9901 4. NOTE: The top of keyhole in bracket must contact the bolt to support the 280 pound (127Kg) enclosure. Align the wireway opening in the enclosure with the wireway opening in the pole. Install bolt, lockwasher and flatwasher through hole inside the enclosure and into the coupling in pole. Wiring and Electrical Instructions The enclosure includes two electrical supply circuits. [. . . ] Once the enclosure is installed, give these instructions to the equipment owner. CLOSE GAPS FIGURE 3 "-SH" HARNESS PLUG CIRCUIT #2 SUPPLY LEADS 7 FIGURE 4 CIRCUIT #1 SUPPLY LEADS 268-1220-9901 [. . . ]