User manual HUBBELL LIGHTING QL5

[. . . ] That the drum's fixing screws have been removed from the back of the washing machine; 2. 6. What goes in your washing machine and how to start your Margherita 2000 (p. 12) A correct distribution of your laundry is vital to the successful outcome of the wash and the life of the washing machine. Learn all the tips and secrets to dividing your linen: colour, type of fabric. Guide to understanding labels (p. [. . . ] One last secret: when washing with cold water, always reduce the amount of detergent you use: it dissolves less easily in cold water than in hot water, so part of it would be wasted. 1 2 3 In compartment 3: Additives (softeners, perfumes, etc. ) 2 The detergent dispenser can be removed and cleaned: just lift it up and pull it outwards , as indicated in the figure. Then leave it under running water for a few minutes. Cutting costs efficiently A guide to environmentally friendly and economic use of your appliance. MAXIMISE THE LOAD SIZE Achieve the best use of energy, water, detergent and time by using the recommended maximum load size. SAVE detergent, time, water and between 5 to 15% energy consumption by NOT selecting Prewash for slight to normally soiled laundry. Pretreat stains with stain remover or soak dried in stains in water before washing to reduce the necessity of a hot wash programme. SAVE energy and time by selecting the highest suitable spin speed to reduce the water content in laundry before using a drying programme. 7 Margherita 2000 - Instructions for installation and use Troubleshooting M ARGHERITA 2000 In most cases, when your washing machine fails to work, the problems arising can be easily solved without having to call for a technician. A circuit breaker may have switched off as a result of too many electrical appliances working at the same time. For safety reasons, the washing machine cannot work if the door is open or not shut properly. Is the programmed start knob, in the correct position for those models concerned?For safety reasons, if the washing machine does not load water, it cannot start a wash cycle. Before calling, read the following But where did all the water go? Simple: with the new Ariston technology, you need less than half of it, to get good results on twice as much!This is why you cannot see the water through the door: because there is little, very little of it, to respect the environment yet without renouncing maximum cleanliness. Turn off the water supply, unplug the appliance and try tightening its attachment. Technical characteristics Model Dimensions QL5 width 59, 5 cm height 85 cm depth 52, 5 cm from 1 to 5 kg voltage 230/240 Volt 50 Hz maximum absorbed power 1850 W maximum pressure 1 MPa (10 bar) minimum pressure 0, 05 MPa (0, 5 bar) drum capacity 40 litre up to 1000 rpm carried out with 4, 5 kg load Capacity Electrical connections Water connections Spinning speed Control programs in compliance with IEC regulation 456 This appliance conforms with the following E. E. C. directives: - 73/23/EEC of 19/02/73 (Low Voltage) and subsequent modifications - 89/336/EEC of 03/05/89 (Electromagnetic Compatibility) and subsequent modifications 9 Margherita 2000 - Instructions for installation and use When Margherita 2000 arrives Whether new or just transported to a new house, installation is extremely important for the correct functioning of your washing machine. After removing the appliance from its packaging, check that it is intact. The inside of the machine is supported, for transportation, by 3 screws on the back panel. The front feet are adjustable. Installation and removal M ARGHERITA 2000 Before using the washing machine, remove the screws, remove the spacers together with the rubber tubes attached to them (keeping all the parts) and use the plastic plugs provided to fill in the holes. Important: Use the cap (provided) to close the 3 holes which housed the stop pin, situated in the righthand part of the lower back of the washing machine. A Part A must not be removed. Levelling The washing machine must be levelled appropriatey in order to guarantee its correct functioning. To level the appliance, the front feet must be adjusted; the angle of inclination, measured according to the worktop, must not exceed 2°. Should you move house then these should be replaced to support the inside of the machine to prevent damage when transporting the machine. Connection to the water mains Both hot and cold water supplies are preferable and they should be between 34. 5kN/m²(5lb/in²) and 1034. 2kN/m² (150lb/in²) pressure. The hose having the red end fitting should be encountered between the hot supply and the threaded connection adjacent to the letter H on the rear of the machine. The hose having the white end fittings should be connected between the cold supply and the threaded connection adjacent to the letter C on the rear of the machine. Remember to insert a sealing washer at each connection to ensure watertight joints. [. . . ] It must only be used by adults and exclusively for washing clothes following the instructions provided in this manual. Should it have to be moved, proceed with the help of two or three people and handle it with the utmost care. Before loading the washing machine, make sure the drum is empty. Your safety and that of your family 5. Never touch the washing machine when barefoot or with wet or damp hands or feet. [. . . ]