User manual HUBBELL LIGHTING CH-EU

[. . . ]  If positioned on a fitted carpet or a rug, adjust the feet in such a way as to allow room for air to circulate and provide ventilation beneath the washing machine.  You will find the guarantee and other details relating to Connecting the cold water and electricity supplies Connecting the water inlet hose Unpacking and levelling Unpacking Before connecting the inlet hose to the cold water supply, allow the water to flow from the tap until it runs clear. 1. Connect the inlet hose to the machine, by screwing it into the cold water inlet on the upper right hand side of the back of the machine (see figure). 1. Once the washing machine has been removed from the packaging, check that it has not been damaged during transportation. If it has been damaged, contact the retailer and do not proceed any further with the installation process. [. . . ] Turn the PROGRAMME KNOB left or right, until the required programme has been selected; the name of the programme will appear on the display. A temperature and spin speed is set for each programme; these may be adjusted. The recommended drum load level and the cycle duration will also appear on the display. Use the relevant buttons on the control panel: Modify the temperature and/or the spin speed. open the door, unload the laundry and switch off the machine.  Exception: if the “Whites” programme is selected, the temperature can be increased up to a value of 90°C. Setting a delayed start. To set a delayed start for the selected programme, press the corresponding button repeatedly until the required delay period has been reached. When this symbol appears option has been activated, the on the display. To remove the delayed start option, press the button until the display shows the text symbol will disappear. OFF; the  If you wish to cancel a cycle that has already button. The cycle will be begun, press and hold the stopped and the machine will switch off. 8 Programmes and options Table of Programmes Icon Programme description Max. spin speed Fabric (r. p. m. ) Washing softener 1600 1600 800 800 l l l l l l l l Maximum load (kg)) Normal Using Mini load 3. Bathroom laundry and bedlinen: this washing machine can be used to wash any domestic laundry in a single cycle called “Weekly washing” that optimises the use of fabric softener while saving both time and electricity. Stubborn stains: stubborn stains should be treated with solid soap before the garment is washed (use the Cotton programme with pre-wash phase).  Do not use detergents when washing garments by hand, because they create too much foam. The detergent must be measured out into the relevant compartment, or into the detergent dosing ball which will be placed directly into the drum of the machine. In this case the Cotton cycle with pre-wash phase may not be selected. Preparing the laundry • Divide the laundry according to type of material (the symbol on the garment label) and colour, making sure that whites are separated from coloured garments. • Do not exceed the values indicated in the “Table of Programmes”, which refer to the weight of the laundry items when they are dry. How much does your laundry weigh? Load-balancing system Before every spin cycle, to avoid excessive vibrations and to distribute the load in a uniform manner, the drum rotates continuously at a speed which is slightly faster than the normal washing speed. If, after several attempts, the load is still not evenly distributed, the machine spins at a lower speed than the set frequency. If the load is excessively unbalanced, the washing machine continues at distribution speed only instead of the full spin speed. In order to achieve better load distribution and balance, we recommend that large and small garments are mixed when placing the laundry in the machine. 1 1 1 1 1 1 1 sheet pillowcase tablecloth bathrobe towel pair of jeans shirt 400 150 400 900 150 400 150 - 500 g 200 g 500 g 1200 g 250 g 500 g 200 g 10 Precautions and tips  This machine was designed and manufactured in compliance with cuurent international safety standards. The following advice is provided for safety reasons and should be read carefully. Opening the porthole door manually If it is not possible to open the porthole door due to a powercut and you wish to hang out the laundry, proceed as follows: 1. Make sure that the water level inside the machine is lower than the door opening; if this is not the case remove excess water using the water outlet hose, collecting it in a bucket as shown in the figure; 3. Remove the covering panel on the front of the washing machine using a screwdriver (see figure). GB General safety • This appliance was designed for domestic use inside the home and is not intended for commercial or industrial use. • The washing machine must be used by adults only, in accordance with the instructions provided in this booklet. [. . . ] • Switch off the machine and unplug the appliance; wait for approximately 1 minute then switch it on again. • The detergent is not designed for machine washing (the packaging should state that the product is “for washing by machine”, “for washing by hand or machine” or similar). • Follow the manual unlocking procedure (see “Precautions and tips”).  If the problem persists after the above checks have been carried out, shut off the water tap, switch off the machine and contact Assistance. 13 The machine does not drain or spin. The washing machine vibrates too much during the spin cycle. The washing machine leaks. The icons corresponding to the “Phase in progress” flash rapidly at the same time as the ON/OFF indicator light. [. . . ]