User manual HOYLES EXITGUARD EX206

[. . . ] If you accidentally enter this mode key O to leave it. The EXITGUARD will be in the OFF mode. Battery Monitor The EX204 EXITGUARD can be powered from 6 x AA alkaline batteries. Before the batteries become exhausted the EXITGUARD will emit periodic warning bleeps and the maintenance LED will flash. On interrogating with the User Code the relevant mode LED will illuminate also with the LED to warn of impending battery failure. [. . . ] Battery Monitor The EX204 EXITGUARD can be powered from 6 x AA alkaline batteries. Before the batteries become exhausted the EXITGUARD will emit periodic warning bleeps and the maintenance LED will flash. On interrogating with the User Code the relevant mode LED will illuminate also with the LED to warn of impending battery failure. The batteries can be changed without losing the user code or set up parameters. Anti Tamper Protection All EXITGUARDs are fitted with tamper detection. If your EXITGUARD is being used for Fire Door Verification you will need to open and close each protected door when the LEDs strobe with a periodic bleep. This may be after entering the building or at a set time determined by a time clock. Installed to operate at am/pm on Mon Tue Wed Thu Fri Sat Sun Door Open Too Long (DOTL) delay Your EXITGUARD may have been set up to incorporate a delay before sounding, usually for fire doors that are in regular use where it would be inconvenient to switch off each time a door is opened for a short period. This feature is NOT installed This feature is installed. The delay is set to secs. Bleep When OFF Your EXITGUARD may have been set up to bleep periodically when in the OFF mode. This feature is NOT installed Your installation engineer should complete the boxes above and leave these instructions with you. Telephone Number: DWG No 60087 Issue 1 Aug 2004 Keypad reset mode 4 5 6 Keypad reset mode 4 5 6 Auto re-arm mode 7 8 0 Auto re-arm mode 7 8 0 Keypad These user instructions apply to EX204, EX205 and EX206 versions of the EXITGUARD. For details on setting various functions refer to Installation Instruction 60086. When your EXITGUARD has been installed and set up you will have been given a 4 digit USER CODE. Make a note of the number in the box above, you will need this number to switch to any of the various modes or to silence the EXITGUARD if it is sounding. When a door opens the EXITGUARD will sound a short chime, like a shop door bell. When the door opens the EXITGUARD sounds until the user code is entered. When the door opens the EXITGUARD sounds and resets a short time after the door is closed (This time delay is usually set to seconds You can interrogate the mode status at any time: Simply type in the User Code, one of the 4 Mode LED will illuminate for a period of 5 seconds. To use Chime Mode enter the USER CODE to interrogate the EXITGUARD and enter 1 before any mode LEDs extinguish. To use Keypad Reset Mode enter the USER CODE to interrogate the EXITGUARD and enter 2 before any mode LEDs extinguish. [. . . ] To use Chime Mode enter the USER CODE to interrogate the EXITGUARD and enter 1 before any mode LEDs extinguish. To use Keypad Reset Mode enter the USER CODE to interrogate the EXITGUARD and enter 2 before any mode LEDs extinguish. To use Auto Re-arm Mode enter the USER CODE to interrogate the EXITGUARD and enter 3 before any mode LEDs extinguish. To switch to the OFF mode enter the USER CODE to interrogate the EXITGUARD and enter O before any mode LEDs extinguish. [. . . ]