User manual HOTPOINT WML 803 B EU.M

[. . . ] Instructions for use WASHING MACHINE Contents GB English, 1 GB GR ΕΛΛΗΝΙΚΑ, 13 BG Áúëãàðñêè, 25 Installation, 2-3 Unpacking and levelling Connecting the electricity and water supplies The first wash cycle Technical data IT Italiano, 37 Care and maintenance, 4 Cutting off the water or electricity supply Cleaning the washing machine Cleaning the detergent dispenser drawer Caring for the door and drum of your appliance Cleaning the pump Checking the water inlet hose Precautions and tips, 5 WML 803 General safety Disposal Description of the washing machine and starting a wash cycle, 6-7 Control panel Indicator lights Starting a wash cycle Wash cycles, 8 Table of wash cycles Personalisation, 9 Setting the temperature Setting the spin speed Functions Detergents and laundry, 10 Detergent dispenser drawer Preparing the laundry Garments requiring special care Load balancing system Troubleshooting, 11 Service, 12 1 Installation GB !This instruction manual should be kept in a safe place for future reference. If the washing machine is sold, transferred or moved, make sure that the instruction manual remains with the machine so that the new owner is able to familiarise himself/herself with its operation and features. Read these instructions carefully: they contain vital information relating to the safe installation and operation of the appliance. [. . . ] START/PAUSE button with indicator light: starts or temporarily interrupts the wash cycles. To pause the wash cycle in progress, press this button; the corresponding indicator light will flash orange, while the indicator light for the current wash cycle phase will remain lit in a fixed manner. If the DOOR LOCKED indicator light is switched off, the door may be opened (wait approximately 3 minutes). To start the wash cycle from the point at which it was interrupted, press this button again. Standby mode This washing machine, in compliance with new energy saving regulations, is fitted with an automatic standby system which is enabled after about 30 minutes if no activity is detected. Press the ON-OFF button briefly and wait for the machine to start up again. 6 Indicator lights The indicator lights provide important information. Start the wash cycle by pressing the START/PAUSE button and the corresponding indicator light will remain lit in a fixed manner, in green. To cancel the set wash cycle, pause the machine by pressing the START/PAUSE button and select a new cycle. The DOOR LOCKED indicator light will switch off, indicating that the door may be opened (wait approximately 3 minutes). Take out your laundry and leave the appliance door ajar to make sure the drum dries completely. Speed (rpm) Total water lt Wash cycles Detergents Prewash Bleach Wash Description of the wash cycle Fabric softener Cycle duration GB 1 2 40° 1000 60° 1000 60° Cotton Standard 60° (1): heavily soiled whites and resistant colours. Delicates Fast Wash 60’: to refresh normal soiled garments quickly (not suitable for wool, silk and clothes which require washing by hand).   (3)    -                -         -                 - 4 4 8 8 3 , 5 3 , 5 4 4 1 , 5 1 3 , 5 8 8 3 3 8 8 8 - - - 190’ 195’ 62 1 , 17 54 , 7 190’ 62 0 , 93 44 0 , 78 62 0 , 80 82 33 30 56 170’ 130’ 120’ 200’ 160’ 85’ 75’ 60’ 210’ 105’ 80’ 30’ 55’ 10’ 3’ 5 5 6 7 8 9 10 60° 40° 60° 40° 40° 30° 60° 20° Cold Water Cold Water Cold Water 1000 1000 1000 1000 800 0 1000 1000 1000 1000 800 1000 1000 11 Cotton Standard 20°: lightly soiled resistant and delicate colours. 12 Eco Cottons 13 Eco Synthetics 14 Eco Fast 30’ Rinse Spin and Pump out Only Drain * 70 0, 05 - and exclude the spin cycle, the machine will drain only. * If you select programme The length of cycle shown on the display or in this booklet is an estimation only and is calculated assuming standard working conditions. The actual duration can vary according to factors such as water temperature and pressure, the amount of detergent used, the amount and type of load inserted, load balancing and any wash options selected. 1) Test wash cycle in compliance with regulation 1061/2010: set wash cycle with a temperature of 60°C. This cycle is designed for cotton loads with a normal soil level and is the most efficient in terms of both electricity and water consumption; it should be used for garments which can be washed at 60°C . 2) Test wash cycle in compliance with regulation 1061/2010: set wash cycle with a temperature of 40°C. This cycle is designed for cotton loads with a normal soil level and is the most efficient in terms of both electricity and water consumption; it should be used for garments which can be washed at 40°C . 3) At 60 °C the “Prewash” function cannot be selected. [. . . ] Extra compartment 4: Bleach Load balancing system Before every spin cycle, to avoid excessive vibrations and to distribute the load in a uniform manner, the drum rotates continuously at a speed which is slightly greater than the washing rotation speed. If, after several attempts, the load is not balanced correctly, the machine spins at a reduced spin speed. If the load is excessively unbalanced, the washing machine performs the distribution process instead of spinning. To encourage improved load distribution and balance, we recommend small and large garments are mixed in the load. [. . . ]