User manual HOTPOINT WML 700 EX.M

[. . . ] Instructions for use WASHING MACHINE Contents GB English, 1 GB FR Français, 15 ES Español, 29 Installation, 2-3-4-5 Unpacking and levelling Connecting the electricity and water supplies The first wash cycle Technical data PT Português, 43 AR ،‫75, عربي‬ Care and maintenance, 6 Cutting off the water or electricity supply Cleaning the washing machine Cleaning the detergent dispenser drawer Caring for the door and drum of your appliance Cleaning the pump Checking the water inlet hose Precautions and tips, 7 WML 700 General safety Disposal Description of the washing machine and starting a wash cycle, 8-9 Control panel Indicator lights Starting a wash cycle Wash cycles, 10 Table of wash cycles Personalisation, 11 Setting the temperature Setting the spin speed Functions Detergents and laundry, 12 Detergent dispenser drawer Preparing the laundry Garments requiring special care Load balancing system Troubleshooting, 13 Service, 14 1 Installation GB !This instruction manual should be kept in a safe place for future reference. If the washing machine is sold, transferred or moved, make sure that the instruction manual remains with the machine so that the new owner is able to familiarise himself/herself with its operation and features. Read these instructions carefully: they contain vital information relating to the safe installation and operation of the appliance. [. . . ] To start the wash cycle from the point at which it was interrupted, press this button again. Standby mode This washing machine, in compliance with new energy saving regulations, is fitted with an automatic standby system which is enabled after about 30 minutes if no activity is detected. Press the ON-OFF button briefly and wait for the machine to start up again. 8 Indicator lights The indicator lights provide important information. This is what they can tell you: Delayed start If the DELAY TIMER function has been activated (see “Personalisation”), after the wash cycle has been started the indicator light corresponding to the selected delay period will begin to flash: Wash cycle phase indicator lights Once the desired wash cycle has been selected and has begun, the indicator lights switch on one by one to indicate which phase of the cycle is currently in progress. Wash Rinse Spin Pump out End of wash cycle END GB As time passes, the remaining delay will be displayed and the corresponding indicator light will flash: Function buttons and corresponding indicator lights When a function is selected, the corresponding indicator light will illuminate. If the selected function is not compatible with the programmed wash cycle, the corresponding indicator light will flash and a sound alert (3 beeps); the function will not be activated. If a function which is incompatible with another function selected previously, only the most recent selection will remain active. Door locked indicator light If this indicator light is on, the appliance door is locked to prevent it from being opened accidentally; to avoid any damage, wait for the indicator light to switch off before you open the appliance door (wait approximately 3 minutes). If the DELAY TIMER function is activated, the door cannot be opened; pause the machine by pressing the START/PAUSE button if you wish to open it. Once the set delay has elapsed, the flashing indicator light will switch off and the selected wash cycle will begin. If the START/PAUSE indicator light (orange) flashes rapidly at the same time as the function indicator light, this indicates a problem has occurred (see “Troubleshooting”). Start the wash cycle by pressing the START/PAUSE button and the corresponding indicator light will remain lit in a fixed manner, in green. To cancel the set wash cycle, pause the machine by pressing the START/PAUSE button and select a new cycle. The DOOR LOCKED indicator light will switch off, indicating that the door may be opened (wait approximately 3 minutes). Take out your laundry and leave the appliance door ajar to make sure the drum dries completely. 9 Wash cycles Table of wash cycles Prewash Bleach Description of the wash cycle Fabric softener Max. 9 Delicates Fast Wash 60’: to refresh normal soiled garments quickly (not 10 suitable for wool, silk and clothes which require washing by hand). 90°) 60° 40° 60° 40° 60° 40° 40° 30° 60° 20° 1000 1000 1000 1000 1000 1000 1000 1000 1000 800 0 1000 1000       -                 -        -                  - 4 4 7 7 7 3 3 4 3 1, 5 1 3, 5 7 7 3 3 7 7 7 180’ 180’ 115’ 195’ 185’ 120’ 110’ 185’ 145’ 80’ 75’ 60’ 180’ 100’ 75’ 30’ 49’ 10’ 3’ 12 Eco Cottons 13 Eco Synthetics 14 Eco Fast 30’ Rinse Spin and Pump out Pump out only * Cold Water 1000 Cold Water 1000 Cold Water 800 1000 1000 and exclude the spin cycle, the machine will drain only. * If you select programme The length of cycle shown on the display or in this booklet is an estimation only and is calculated assuming standard working conditions. The actual duration can vary according to factors such as water temperature and pressure, the amount of detergent used, the amount and type of load inserted, load balancing and any wash options selected. 1) Test wash cycle in compliance with regulation 1061/2010: set wash cycle 4 with a temperature of 60°C. [. . . ] If, after several attempts, the load is not balanced correctly, the machine spins at a reduced spin speed. If the load is excessively unbalanced, the washing machine performs the distribution process instead of spinning. To encourage improved load distribution and balance, we recommend small and large garments are mixed in the load. Preparing the laundry • Divide the laundry according to: - the type of fabric/the symbol on the label - the colours: separate coloured garments from whites. [. . . ]