User manual HOTPOINT WK 24E UM0

[. . . ] The manufacturer declines all responsibility for innapropiate use or incorrect setting of the controls. €¢ CAUTION : The appliance is not intended to be operated by means of an external timer or separate remote control system. 11 en it • Do not store explosive or flammable substances such as aerosol cans and do not place or use gasoline or other flammable materials in or near the appliance: a fire may break out if the appliance is inadvertently switched on. €¢ Do not use accessories or attachments that are not recommended by the appliance manufacturer. [. . . ] €¢ If the power supply is cut, the appliance stays ON and starts again operating as soon as the power supply is restored. 13 en it ELECTRICAL CONNECTIONS Socket outlet / plug If the fitted plug is not suitable for your socket outlet, contact AfterSales Service for further instruction. This procedure needs to be carried out by a qualified technician in compliance with the manufacturer’s instructions and current standard safety regulations. CORRECT USE • Turn the appliance off and unplug from the supply outlet when not in use, before cleaning, assembly, disassembly or interacting with any accessory. €¢ Do not leave the appliance unattended while is operating. €¢ Ensure that the switch is free or obstructions and the lid is firmly closed. The kettle will not turn off if the switch is constrained or if the lid is open. €¢ Do not operate the appliance empty to avoid damaging the heating elements. Do not add water over the maximum level, as it may spill out of the spout when boiling. Ensure that the lid is firmly in place before connecting the plug into a power unit. €¢ While the water is boiling or just after the water has boiled, avoid any contact with the steam. Therefore use only the handle to pick it up and open the lid only after the kettle has cooled down. €¢ Extreme caution must be used when moving an appliance full of hot water. €¢ Always take care to pour boiling water slowly and carefully without tipping the kettle too fast as boiling water may cause scalds. 14 en it CLEANING AND MAINTENANCE • The appliance must be disconnected from the power supply before carrying out any cleaning or maintenance operation. €¢ Carefully wipe the ouside of the appliance to remove any dust that may have accumulated, then dry it with a soft cloth. Do not use any harsh abrasive cleaners, alkaline cleaning agents or scouring agents. €¢ Wash the accessories in warm soapy water, then dry with a dry towl. Water gauge Kettle Spout Limescale filter (removable) Lid Lid opening button Handle Display Temperature setting button Start/stop button Cable Base the spout. The water level should not exceed the maximum level or sit below the min level. Too little water will cause the kettle to switch off before the water has boiled. Do not add water over the maximum level, as it may spill out of the spout when boiling. [. . . ] This appliance is manufactured with recyclable (*) or reusable materials. For further information on the treatment, recovery and recycling of household electrical appliances, contact your competent local authority, the collection service for household waste or the store where you purchased the appliance. This appliance is marked in compliance with European Directive 2012/19/EU, Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. [. . . ]