User manual HOTPOINT VS S15 AAW

[. . . ] € Do not walk on surfaces which have just been cleaned before they are dry. Please only use tools recommended by the producer • The following uses are forbidden: -using the device as humidifier or as heater, -on surfaces which can get in touch with food, -on walls, shelves, windows and beyond your head’s height, -without the cleaning cloth -in the open air. € To protect against fire or electric shocks: A) Never immerse the device in water or other liquids. B) Don’t handle the plug or other devices with we hands or with bare feet. [. . . ] Do not use on wooden unsealed floors and on floors made on nonenamelled ceramic floors. The action of both heat and steam could remove the brightness on floors previously treated with wax. We always recommend to test your device on an isolated area of the floor before you use it on the whole surface. Please check the usage and maintenance instructions given by the producer of your floor. € • • • • • • • • • • • • • • • • • • BEFORE USE The product is inspected with different tests before it is produced and sold in order to guarantee a higher level of quality. This is the reason why it’s normal to find some water drops in the tank when you open the box. please remove all stickers , protective plastic or carton boxes from the device itself. Insert the handling pipe (8) in the pipe housing handle (7) until it stops. Insert the dust container (2) in its housing, by positioning first in the upper part and then in the lower part until you hear the click of “closing complete”. [Tap water : de-mineralized water] Ratio 1:0 2:1 1:1 1:2 0:1 USE OF THE VACUUM MODE (B) Do not use the device without filters (14) or without the dust container (2), ad it could get damaged. Unwind the power cable (12) and insert the plug of the device in a wall socket (220-240V). Before you connect the device to the electrical plug, please unwind all the power cable to avoid its heating up and avoid damaging it. Turn the power electronic regulator clockwise (3) in order start the device in vacuum mode. Position the power electronic regulator so that it is in line with the symbol. In order to turn off the device, please turn the power electronic regulator anticlockwise by positioning it in line with the Off symbol. Wind the cable around the top cable-winder support (10) and the bottom cable-winder support (11). Pull and turn the top cable-winder support to completely unwind the cable. Before you connect the plug to the wall socket, please completely unwind the power cable in order to avoid its overheating or to avoid damaging it. It could be useful to vacuum the floor before you use the device in steam mode. Please position the cloth under the steam cleaning tool (16) and then the device on it. Turn the power electronic regulator anticlockwise (3) in order start the device in steam mode. Position the power electronic regulator so that it is in line with the symbol Before you start using the device, wait for it to heat up (20 seconds). [. . . ] For your safety, the steam is emitted only if the device is not in its rest position. After turning on the device, please wait 20 seconds until it heats up. Turn off the device by disconnecting the plug from the wall socket and replace the cloth. If you wash the cloth with powder detergent, the dust could remain trapped in the cloth. [. . . ]