User manual HOTPOINT TQG 752 W/HA(ICE)

[. . . ] Operating Instructions, 1 Warnings, 3 Assistance, 8 Description of the appliance, 10 Installation, 19 Start-up and use, 23 Precautions and tips, 23 Maintenance and care, 24 Troubleshooting, 24 WARNING: The appliance and its accessible parts become hot during use. Children less than 8 years of age shall be kept away unless continuously supervised. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Cleaning and user maintenance shall not be made by children without supervision. [. . . ] Before connecting to the power supply, make sure that: · The appliance is earthed and the plug is compliant with the law. The socket can withstand the maximum power of the appliance, which is The voltage is in the range between the values indicated on the data plate. if the socket is Incompatible with the plug, ask an authorised technician to replace it. Once the appliance has been installed, the power supply cable and the electrical socket must be easily accessible. Before connection remove a transport plug from the connecting hole of the cooker gas pipeline. Connection to the gas system must be carried out in such a way as not to place any strain of any kind on the appliance. There is an adjustable L-shaped pipe fitting on the appliance supply ramp and this is fitted with a seal in order to prevent leaks. The seal must always be replaced after rotating the pipe fitting (seal provided with appliance). These pipes must be installed so that they are never longer than 2000 mm when fully extended. Once connection has been carried out, make sure that the flexible metal pipe does not touch any moving parts and is not compressed. Only use pipes and seals that comply with current national regulations. When the installation process is complete, check the pipe fittings for leaks using a soapy solution. Adapting to different types of gas To adapt the hob to a different type of gas other than default type (indicated on the rating plate at the base of the hob or on the packaging), the burner nozzles should be replaced as follows: 1. Unscrew the nozzles using a 7 mm socket spanner, and replace them With nozzles for the new type of gas (see table 1 "Burner and nozzle characteristics"). In the case of the Mini WOK burner, use a spanner with a 7 mm opening to unscrew the nozzle (see figure). The cable must be checked regularly and replaced by authorised technicians only (see Assistance). The manufacturer declines any liability should these safety measures not be observed. Reassemble the parts following the above procedure in the reverse order. Once this procedure is finished, replace the old rating sticker with one Indicating the new type of gas used. Remove the knob and adjust the adjustment screw, which is positioned In or next to the tap pin, until the flame is small but steady. Having adjusted the flame to the required low setting, while the burner is Alight, quickly change the position of the knob from minimum to maximum and vice versa several times, checking that the flame does not go out. If the device fails to work when the burners are set to the low flame setting, increase this low flame setting using the adjusting screw. [. . . ] Old appliances must be collected separately in order to optimise the recovery and recycling of the materials they contain and reduce the impact on Human health and the environment. The crossed out "wheeled bin" symbol On the product reminds you of your obligation, that when you dispose of The appliance it must be separately collected. Consumers should contact their local authority or retailer for information Concerning the correct disposal of their old appliance. Cook your food in closed pots or pans with well-fitting lids and use as little water as possible. [. . . ]