User manual HOTPOINT TCS 73B GP

[. . . ] To activate you free* 5 years parts guarantee Call free on 0800 519 2102 *Labour charges not included. 1 Installation GB Where to install the tumble dryer • Install the dryer far from gas ranges, stoves, radiators or hobs, as flames may damage it. If the dryer is installed below a worktop, en15 mm 15 mm sure there are 10 mm between the upper panel of the dryer and any objects above it, and 15 mm between the sides of the machine and the walls or furniture units adjacent to it. The appliance must be installed with the rear surface placed against a wall. [. . . ] The “Clean condenser unit” indicator light Care and maintenance). (CLEAN CONDENSER) signals that it is essential to clean the condenser regularly (see “Drying phases” indicator lights The The DRYING indicator light signals that the drying phase is running. COOL TUMBLE indicator light signals that the cooling phase is running. €Delay timer” indicator light If the ”Delay timer” option has been activated (see “Programmes and options”), after the programme has started, the indicator light corresponding to the chosen delay time will start flashing: As time passes, the remaining delay will be displayed and the corresponding indicator light will flash: Once the set delay time ends, the flashing LED will turn off and the set programme will start. 9 How to carry out a drying cycle GB Starting and selecting a programme 1. Open the door, ensure that the filter is clean and securely placed and that the water container is empty and correctly located (see Care and maintenance). Load the machine, making sure that no piece of laundry gets between the door and the relative seal. After consulting the programme chart and the indications for each type of fabric (see Laundry), turn the Programme selection knob towards the programme corresponding to the type of laundry to be dried (see Programmes and options). Warning: If the position of the programme selection knob changes after pressing the START/PAUSE button, the selected programme will NOT be modified. To modify the programme, press the START/PAUSE button to put the programme in pause mode (the indicator light flashes orange), then select a new programme and the relative options. If necessary, set the time of the delayed start and any other options (see Programmes and options). Anti Allergy This programme has the ‘Seal of Approval’ endorsement from Allergy UK, which reflects the effective reduction and elimination of allergens from the clothes with the special Anti Allergy cycle. With this programme, thanks to the achievement of constant temperature for an extended period of time, the effects of the most common allergens (including House Mites) are neutralised. Can be used on a full size wet load to dry and treat, or on a 4kg dry load just to treat your laundry. The filter should be cleaned in order to ensure the correct operation of the cycle’s anti-allergy function. 11 GB Shirts ● This is a programme for shirts made from cotton. Shirts and Fibre Care option ●This is a programme for shirts made from synthetic materials or a mixture of natural and synthetic materials, such as polyester and cotton. Loads dried using this program are usually ready to wear, the edges or seams may be slightly damp. If this is the case, try turning the shirts inside out and running the programme again for a short period. — It can also be used on other garments made from the same material, such as jackets. — Loads dried using this programme are usually ready to wear, the edges or seams may be slightly damp. If this is the case, try turning the jeans inside out and running the programme again for a short period. [. . . ] If the noise persists during the entire cycle, contact the Technical Assistance Centre. It occurs after 30 minutes: - if you leave the dryer without starting a programme; - after your drying programme has finished. Turn the knob to the desired program to restart dryer operation (to start the program press START/PAUSE). The lights on the dryer control panel are off although the dryer is switched on. [. . . ]