User manual HOTPOINT TCL 87B P

[. . . ] Instruction booklet TUMBLE DRYER GB I English, 1 P GR Contents Important information, 2-3 Installation, 4 Where to put your dryer Ventilation Water drain Electrical connection Before you start using your dryer GB Português, 17 EÏÏËÓÈο, 33 Dryer description, 5 The features Control panel Start and programmes, 6-10 Choosing a programme Programmes and Tables The controls TCL 87 Laundry, 11-12 Sorting your laundry Wash care labels Special clothing items Drying times Warnings and Suggestions, 13 General safety Saving energy and respecting the environment Maintenance and Care, 14 Switching off the electricity Cleaning the filter after each cycle Check the drum after each cycle Empty the water container after each cycle Cleaning the condenser unit Cleaning the dryer Troubleshooting, 15 Service, 16 Disposal !Keep this instruction booklet on hand in order to refer to it when necessary. Take it with you when you move, and should you sell this appliance or pass it on to another party, make sure that this booklet is supplied along with the dryer so that the new owner may be informed about warnings and suggestions on how the appliance works. Read these instructions carefully; the following pages contain important information on installation and suggestions on how the appliance works. [. . . ] Select the new programme and any options required, the light will then flash green. OPTION buttons / lights These buttons are used to customise the selected programme to your requirements. Not all options are available for all programmes (see Start and Programmes). If an option is not available and you press the button, the buzzer will beep three times. If the option is available the option light next to the button lights to confirm the selection. Progress ( Drying, Cool Tumble, End) / Delay (3hr 6hr 9hr) Lights When the light next to the delay button is on, these lights flash to indicate the delay time selected. During other programmes they indicate the progress of the dryer, each one comes on as the corresponding phase starts. Delay Timer The start of some programmes (see Start and Programmes) can be delayed for up to 9 hours in 3hr steps. When a delayed start is in progress the light next to the delay button will be on and the selected delay period light will flash (after the start button has been pressed). To set a delayed start, press the Delay Timer button, and the light next to the button will come on together with the 3hr delay light. Pressing the button again will advance the delay setting to 6hr, the 3hr light goes out and the 6hr light is on. Each time you press the button the delay setting advances 3 hours, as indicated by the corresponding light. If the 9hr light is on, pressing the button again will cancel the delay. Selecting this option enables both the pre and post care functions if appropriate. High Heat Press this button and a high heat setting is selected and the light next to the button comes on. If the light alongside the button is on then pressing the button selects a low heat setting and the light goes out. Empty Water Light / Container (If you have plumbed your dryer to a drain this light can be ignored, as there is no need to empty the water container). When this light is on (not flashing) it reminds you to empty the water container. If the water container fills during a programme, the heater turns off and the dryer does a period of Cool Tumble then the light flashes and the buzzer sounds. You must empty the water container and restart the dryer or the clothes will not dry. After re-starting the dryer, the light will take a few seconds to go out. To avoid this always empty the water container each time you use the dryer (see Maintenance). [. . . ] The air intake grille is obstructed (see Installation, and see Maintenance). The water container was probably not emptied at the start of the programme. Do not wait for the empty water signal, always check and empty the container before starting a new drying programme (see Maintenance). If the light is on but not flashing it is just a reminder to empty the container (see Start and Programmes). [. . . ]