User manual HOTPOINT TB 050 DSL0

[. . . ] Return the appliance to the nearest authorized service facility for examination, repair or adjustment. Be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. Close supervision is necessary when any appliance is used by or near children. [. . . ] Ppliances can be used A by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and if they understand the hazards involved. Before the first use, unpack the appliance and place all parts on a horizontal surface. The jar assembly (including measuring cup, lid, gasket 1, jar unit, gasket 2 , blade assembly ) has already been assembled into the motor unit. Holding the jar handle, invert the jar onto a level surface, put the jar base onto the jar bottom and secure the jar base by turning it clockwise until tight (See Fig. Place the gasket 2 and the blade assembly onto the jar and secure the jar base by turning it anticlockwise until tight (See Fig. Wrap the gasket 1 around the lid bottom and put the lid onto the jar assembly. Place the measure cup exactly into the lid by fitting the small projection on the both sides of the cup into the slots of the lid and turning the cup clockwise until tight. Finally, place the assembled jar onto the motor unit by aligning the arrow symbol on the jar base to the unlock symbol on the motor unit and turning the jar clockwise until tight. The amount of mixture should not exceed the max level as indicated on the jar. For quick or delicate blending tasks, turn the speed knob to P position and hold for a few seconds and then release; the knob will reset to 0 position automatically. If you want to add ingredients while the blender is working, remove the measuring cup and place through the lid opening. When the consistence you desire is obtained, 13 en it turn the knob to 0 position. Note: For each use, the consecutive operation time should not exceed 3 minutes. At least 10 minutes rest time must be maintained between two continuous cycles. In any case, let the unit cool to room temperature before performing next operation cycle. Note: If you want to stop the machine during operation, turn the knob to O position anytime. Brush the blades using warm soapy water, then rinse thoroughly under the tap. Attention: Don’t immerse the blade assembly in water Attention: Leave to dry upside down away from children. [. . . ] Lift the jar assembly off the motor unit, detach the blade assembly by turning it clockwise from the jar base bottom , and remove the gasket 2 and blade assembly (See Fig. Rinse measuring cup, lid, gaskets, jar unit and blade assembly by hands or into the dishwasher and then dry. They are dishwasher safe components, but the temperature setting shall Old appliances must be collected separately in order to optimise the recovery and recycling of the materials they contain and reduce the impact on human health and the environment. [. . . ]